Table of Contents
Installing the Mishimoto Cold Air Intake on your BRZ FA24 can significantly enhance your vehicle’s performance, providing a gain of up to 15 horsepower. This article will guide you through the installation process, ensuring that you can achieve optimal results. Follow the steps carefully for a successful installation.
Tools and Materials Needed
- Mishimoto Cold Air Intake Kit
- Socket wrench set
- Flathead screwdriver
- Phillips screwdriver
- Torx bit set
- Rubber gloves
- Shop towel
- Safety glasses
Before starting the installation, gather all necessary tools and materials. This will ensure that you do not have to make interruptions during the process.
Preparation Steps
Preparation is key to a smooth installation. Follow these steps to prepare your vehicle:
- Ensure the vehicle is parked on a flat surface.
- Disconnect the negative battery terminal to avoid any electrical issues.
- Allow the engine to cool if it has been running.
Removing the Stock Air Intake
To install the Mishimoto Cold Air Intake, you must first remove the stock air intake system. Follow these steps:
- Locate the air intake box and remove the screws using the appropriate screwdriver.
- Disconnect the mass air flow (MAF) sensor by gently pulling the connector.
- Loosen the hose clamp that secures the intake tube to the throttle body using a socket wrench.
- Carefully remove the intake tube and air box from the engine bay.
Installing the Mishimoto Cold Air Intake
Now that the stock intake is removed, it’s time to install the Mishimoto Cold Air Intake. Follow these steps:
- Place the new Mishimoto air intake box into the engine bay.
- Secure the air intake box with the screws provided in the kit.
- Connect the MAF sensor to the new intake tube.
- Align the intake tube with the throttle body and tighten the hose clamp.
- Ensure all connections are secure and there are no loose parts.
Final Steps
After installing the new intake system, there are a few final checks to complete:
- Recheck all connections to ensure they are tight.
- Reconnect the negative battery terminal.
- Start the engine and listen for any unusual noises.
- Take the vehicle for a test drive to experience the performance gain.
Conclusion
Installing the Mishimoto Cold Air Intake on your BRZ FA24 is a straightforward process that can lead to a significant performance boost. By following these steps, you can enhance your driving experience and enjoy the added horsepower. Always remember to follow safety precautions and consult the Mishimoto manual for specific instructions related to your model.