Install Guide: Apr’s 2.7t Intake and Downpipe for 60+ Hp Boost

by

Upgrading your vehicle’s performance can be an exciting venture, especially when it comes to enhancing horsepower. This guide will walk you through the installation of APR’s 2.7T intake and downpipe, designed to provide an impressive boost of over 60 horsepower. Follow these steps carefully to ensure a successful installation.

Tools and Equipment Needed

  • Socket set
  • Torque wrench
  • Screwdrivers (flathead and Phillips)
  • Pliers
  • Ratchet and extensions
  • Shop towels
  • Safety glasses

Preparation

Before starting the installation, ensure your vehicle is parked on a flat surface and the engine is cool. Gather all necessary tools and components. It’s also advisable to wear safety glasses to protect your eyes during the process.

Removing the Stock Intake

To begin, you need to remove the stock intake system. Follow these steps:

  • Locate the airbox and disconnect the MAF sensor plug.
  • Unscrew the clamps holding the intake hose to the throttle body.
  • Remove any additional screws or clips securing the airbox.
  • Carefully lift the airbox out of the engine bay.

Installing APR’s 2.7T Intake

With the stock intake removed, you can now install the APR 2.7T intake:

  • Position the new intake into the engine bay.
  • Connect the intake hose to the throttle body and secure it with the clamp.
  • Reconnect the MAF sensor plug.
  • Ensure all connections are tight and secure.

Removing the Stock Downpipe

Next, you will need to remove the stock downpipe. Follow these steps:

  • Lift the vehicle using a jack and secure it with jack stands.
  • Locate the downpipe and disconnect the exhaust flange bolts.
  • Remove any heat shields that may obstruct access.
  • Unscrew the bolts connecting the downpipe to the turbo.
  • Carefully remove the downpipe from the vehicle.

Installing APR’s Downpipe

Now it’s time to install the APR downpipe:

  • Position the new downpipe into place.
  • Reconnect the downpipe to the turbo using the supplied bolts.
  • Secure the downpipe to the exhaust flange.
  • Reinstall any heat shields that were removed.

Final Checks

After everything is installed, perform the following checks:

  • Ensure all bolts and clamps are tightened to the manufacturer’s specifications.
  • Check for any leaks around the connections.
  • Start the engine and listen for any unusual sounds.
  • Allow the engine to reach operating temperature and monitor performance.

Conclusion

Installing APR’s 2.7T intake and downpipe can significantly enhance your vehicle’s performance. By following this guide, you can ensure a smooth installation process. Enjoy the added horsepower and improved driving experience!