Table of Contents
The AWE Tuning Cold Air Intake is a popular upgrade for the Audi TTRS 2.5 TFSI, enhancing performance and engine sound. This guide will walk you through the installation process step-by-step to ensure a smooth and successful upgrade.
Tools and Materials Needed
- Socket set (including 10mm and 13mm sockets)
- Flathead screwdriver
- Phillips screwdriver
- Torque wrench
- Ratchet
- New AWE Tuning Cold Air Intake kit
- Shop towels
Preparation Steps
Before starting the installation, ensure your vehicle is parked on a flat surface and the engine is cool. Gather all necessary tools and materials to avoid interruptions during the installation.
Disconnect the Battery
To ensure safety while working on your vehicle, disconnect the negative terminal of the battery. This step prevents any accidental electrical shorts.
Remove the Engine Cover
Using a socket wrench, remove the bolts securing the engine cover. Carefully lift the cover off and set it aside. This will expose the factory air intake system.
Removing the Factory Air Intake
With the engine cover removed, you can now proceed to uninstall the factory air intake system. Follow these steps carefully.
Loosen the Clamps
Locate the clamps securing the factory intake hose to the turbo inlet and the airbox. Use a flathead screwdriver to loosen these clamps.
Disconnect the Intake Hose
Once the clamps are loosened, gently pull the intake hose away from the turbo inlet and airbox. Be cautious not to damage any surrounding components.
Remove the Airbox
Remove any bolts securing the airbox in place using a socket wrench. After removing the bolts, lift the airbox out of the engine bay.
Installing the AWE Tuning Cold Air Intake
Now that the factory air intake is removed, it’s time to install the AWE Tuning Cold Air Intake. Follow these steps for a successful installation.
Position the New Air Intake
Take the AWE Tuning Cold Air Intake and position it in the engine bay where the factory airbox was located. Ensure that it aligns properly with the turbo inlet.
Secure the Air Intake
Using the provided bolts, secure the new air intake in place. Make sure it is tightly fastened to prevent any movement during operation.
Connect the Intake Hose
Attach the intake hose to the turbo inlet and the new air intake. Tighten the clamps to ensure a secure fit.
Final Steps
With the new cold air intake installed, it’s important to reassemble any components removed during the process.
Reinstall the Engine Cover
Place the engine cover back over the engine bay and secure it with the bolts you previously removed. Ensure everything is aligned properly.
Reconnect the Battery
Reconnect the negative terminal of the battery. Make sure it is tightly secured to avoid any electrical issues.
Testing the Installation
After completing the installation, it’s essential to test your vehicle to ensure everything is functioning correctly. Start your engine and listen for any unusual sounds.
Check for Leaks
Inspect the intake connections for any signs of leaks or loose fittings. If everything appears secure, you have successfully installed your AWE Tuning Cold Air Intake.
Conclusion
Installing the AWE Tuning Cold Air Intake on your TTRS 2.5 TFSI can enhance performance and provide a more aggressive engine sound. By following this guide, you can ensure a successful installation and enjoy the benefits of your new upgrade.