Table of Contents
Installing a Mann+Hummel high-flow oil filter on your CLA45 AMG can enhance engine performance and ensure better oil flow. This guide will walk you through the installation process in just 30 minutes.
Tools and Materials Needed
- Mann+Hummel high-flow oil filter
- Oil filter wrench
- Socket set
- Torque wrench
- Oil catch pan
- New engine oil
- Rags or paper towels
Preparation Steps
Before starting the installation, make sure your vehicle is on a flat surface and the engine is cool. Gather all the tools and materials listed above.
Step 1: Safety First
Ensure that you wear safety glasses and gloves to protect yourself from any oil spills or debris.
Step 2: Lift the Vehicle
Use a jack to lift the front of your CLA45 AMG and secure it with jack stands. This will provide better access to the oil filter.
Removing the Old Oil Filter
Locate the oil filter, which is typically situated near the engine block. Use the oil catch pan to collect any oil that may spill during the removal process.
Step 3: Drain the Oil
Remove the drain plug from the oil pan and allow the old oil to drain completely into the catch pan. Replace the drain plug once done.
Step 4: Unscrew the Old Filter
Using the oil filter wrench, carefully unscrew the old oil filter. Make sure to wipe the area around the filter with a rag to prevent debris from entering the engine.
Installing the Mann+Hummel High-Flow Oil Filter
Now that the old filter is removed, it’s time to install the new Mann+Hummel high-flow oil filter.
Step 5: Prepare the New Filter
Before installation, apply a small amount of new engine oil to the rubber gasket on the new filter. This helps create a better seal.
Step 6: Screw in the New Filter
Carefully screw the new Mann+Hummel filter into place by hand. Once it’s snug, use the oil filter wrench to tighten it further, but avoid over-tightening.
Refilling Engine Oil
With the new filter installed, it’s time to refill the engine with new oil.
Step 7: Add New Engine Oil
Remove the oil filler cap and pour in the recommended amount of new engine oil. Refer to your owner’s manual for the exact specifications.
Step 8: Check Oil Level
After adding oil, wait a few minutes and then use the dipstick to check the oil level. Add more oil if necessary.
Final Steps
Once everything is in place, it’s time to start the engine and check for leaks.
Step 9: Start the Engine
Run the engine for a few minutes and check around the oil filter for any signs of leaking oil. If there are no leaks, you are good to go.
Step 10: Dispose of Old Oil and Filter
Properly dispose of the old oil and oil filter at a recycling center to ensure environmental safety.
Conclusion
Installing a Mann+Hummel high-flow oil filter on your CLA45 AMG can be completed in just 30 minutes with the right tools and steps. Regular maintenance will keep your engine running smoothly and efficiently.