Table of Contents
Installing wheel spacers on your Honda Civic can enhance its appearance and improve handling. This guide will walk you through the steps to safely fit 10mm and 20mm wheel spacers. Always ensure you follow the instructions carefully for the best results.
Tools and Materials Needed
- 10mm or 20mm wheel spacers
- Jack and jack stands
- Tire iron
- Torque wrench
- Wheel cleaner
- Lug nut socket
Before you begin, gather all the tools and materials listed above. This will ensure a smooth installation process without interruptions.
Preparation Steps
Proper preparation is key to a successful installation. Follow these steps before fitting the spacers:
- Park your Honda Civic on a flat surface.
- Engage the parking brake to prevent any movement.
- Loosen the lug nuts on the wheels you will be working on.
Jack Up the Vehicle
Once the wheels are prepared, it’s time to lift the vehicle:
- Place the jack under the designated jack points on your Civic.
- Lift the vehicle until the wheels are off the ground.
- Secure the vehicle with jack stands for safety.
Remove the Wheels
With the vehicle securely lifted, you can now remove the wheels:
- Completely remove the loosened lug nuts.
- Carefully take off the wheel and set it aside.
Clean the Hub Surface
Before installing the spacers, it’s important to clean the hub:
- Use wheel cleaner to remove dirt and debris from the hub surface.
- Ensure the surface is dry and free of contaminants.
Install the Wheel Spacers
Now you can install the wheel spacers:
- Align the spacer with the hub and press it into place.
- Ensure that the spacer is seated properly.
- Attach the provided lug nuts that come with the spacers.
Reinstall the Wheels
With the spacers installed, it’s time to put the wheels back on:
- Align the wheel with the spacer and hub.
- Hand-tighten the lug nuts to hold the wheel in place.
Torque the Lug Nuts
After installing the wheels, it’s crucial to torque the lug nuts:
- Using a torque wrench, tighten the lug nuts to the manufacturer’s specifications.
- Follow a crisscross pattern to ensure even tightening.
Lower the Vehicle
Once everything is tightened, you can lower your Honda Civic:
- Remove the jack stands carefully.
- Lower the vehicle back to the ground using the jack.
Final Checks
After lowering the vehicle, perform the following checks:
- Recheck the torque on the lug nuts after a short drive.
- Inspect the wheel alignment and spacing for any issues.
Conclusion
Fitting 10mm and 20mm wheel spacers on your Honda Civic can be a straightforward process if done correctly. By following this guide, you can ensure a safe and effective installation that enhances both the look and performance of your vehicle.