Table of Contents
Installing StopTech Street Performance Brake Pads can enhance your vehicle’s braking performance significantly. This guide will provide you with step-by-step instructions to ensure a successful installation.
Tools and Materials Needed
- StopTech Street Performance Brake Pads
- Jack and jack stands
- Lug wrench
- Brake cleaner
- Torque wrench
- Socket set
- Rags or shop towels
- Grease or brake lubricant
Preparation Steps
Before you begin the installation, ensure your vehicle is parked on a flat surface and the engine is off. Gather all the tools and materials listed above.
1. Lift the Vehicle
Using the jack, lift the front or rear of the vehicle, depending on which brake pads you are changing. Secure the vehicle with jack stands for safety.
2. Remove the Wheel
Using the lug wrench, loosen and remove the lug nuts. Carefully take off the wheel and set it aside.
Removing Old Brake Pads
Once the wheel is removed, you can access the brake caliper and pads.
1. Remove the Caliper Bolts
Locate the caliper bolts and use the appropriate socket to remove them. Keep these bolts in a safe place as you will need them for reinstallation.
2. Slide Off the Caliper
Carefully slide the caliper off the brake rotor. Support the caliper with a bungee cord or rope to avoid straining the brake line.
3. Remove Old Brake Pads
Take out the old brake pads from the caliper bracket. Note their orientation for the installation of the new pads.
Installing StopTech Street Performance Brake Pads
Now that the old pads are removed, it’s time to install the new StopTech brake pads.
1. Prepare the New Brake Pads
Before installation, apply a thin layer of brake lubricant to the backing of the new brake pads to reduce noise and ensure smooth operation.
2. Install New Brake Pads
Position the new brake pads into the caliper bracket in the same orientation as the old pads. Ensure they are securely in place.
3. Reinstall the Caliper
Carefully slide the caliper back over the new brake pads and align it with the caliper bracket. Reinsert and tighten the caliper bolts.
Final Steps
After installing the new brake pads, you need to reassemble everything properly.
1. Reattach the Wheel
Place the wheel back onto the hub and hand-tighten the lug nuts. Ensure the wheel is secure before lowering the vehicle.
2. Lower the Vehicle
Remove the jack stands and carefully lower the vehicle back to the ground.
3. Torque the Lug Nuts
Using the torque wrench, tighten the lug nuts to the manufacturer’s specifications to ensure they are secure.
Testing Your Brake Pads
After installation, it is crucial to test your new brake pads to ensure they are functioning correctly.
1. Pump the Brake Pedal
Before driving, pump the brake pedal several times to seat the new pads against the rotor. This will help improve braking performance.
2. Conduct a Test Drive
Take your vehicle for a short test drive in a safe area. Test the brakes at low speeds to ensure they are functioning properly.
Conclusion
Installing StopTech Street Performance Brake Pads is a straightforward process that can significantly enhance your vehicle’s braking capabilities. By following these steps, you can ensure a successful installation and improved safety on the road.