Table of Contents
Upgrading the brakes on your Porsche 911 is an essential improvement for both performance and safety. One of the best options on the market is the EBC Redstuff Ceramic Pads. This article will provide you with valuable installation tips to ensure a smooth upgrade process.
Understanding EBC Redstuff Ceramic Pads
EBC Redstuff Ceramic Pads are designed for high-performance vehicles like the Porsche 911. They offer superior stopping power, reduced brake dust, and quieter operation compared to standard pads. Understanding their features will help you appreciate the benefits of this upgrade.
Necessary Tools and Materials
Before starting the installation, gather the following tools and materials:
- Jack and jack stands
- Torque wrench
- Socket set
- Screwdriver set
- Brake cleaner
- Grease for brake components
- EBC Redstuff Ceramic Pads
Step-by-Step Installation Guide
1. Prepare Your Vehicle
Start by parking your Porsche 911 on a flat surface. Engage the parking brake and place wheel chocks behind the rear wheels to prevent any movement.
2. Lift the Vehicle
Using a jack, lift the front or rear of the vehicle, depending on which brakes you are upgrading. Secure the vehicle with jack stands to ensure safety while you work.
3. Remove the Wheel
Use a socket set to remove the lug nuts and take off the wheel. This will give you access to the brake components.
4. Remove the Brake Caliper
Locate the caliper bolts and use the appropriate socket to remove them. Carefully slide the caliper off the rotor and support it with a bungee cord or a piece of wire to avoid straining the brake line.
5. Remove Old Brake Pads
Once the caliper is removed, take out the old brake pads. Inspect the caliper for any signs of wear or damage while you have it exposed.
6. Clean the Brake Components
Use brake cleaner to clean the caliper and rotor surface. This will remove any debris and old brake dust, ensuring optimal performance for the new pads.
7. Install EBC Redstuff Ceramic Pads
Place the new EBC Redstuff Ceramic Pads into the caliper bracket. Ensure they are seated properly and aligned with the rotor.
8. Reattach the Brake Caliper
Carefully slide the caliper back over the new pads and rotor. Reinstall the caliper bolts and tighten them to the manufacturer’s specifications using a torque wrench.
9. Reinstall the Wheel
Place the wheel back onto the hub and hand-tighten the lug nuts. Lower the vehicle back to the ground and then use the torque wrench to tighten the lug nuts to the specified torque setting.
10. Repeat for Other Wheels
If you are upgrading all four brakes, repeat the above steps for the other wheels. Ensure that all components are securely fastened before driving.
Post-Installation Tips
After installation, it’s important to break in your new EBC Redstuff Ceramic Pads properly. Follow these guidelines:
- Avoid hard braking for the first 200 miles.
- Gradually increase braking pressure to allow the pads to seat correctly.
- Monitor brake performance and listen for any unusual noises.
Conclusion
Upgrading your Porsche 911’s brakes with EBC Redstuff Ceramic Pads can greatly enhance your driving experience. By following these installation tips, you can ensure a successful upgrade that improves performance and safety.