Table of Contents
Installing a two-step launch control can significantly improve your Ford Mustang’s performance during drag racing. This guide will walk you through the steps to install a $150 Purge Two-Step Launch Control, ensuring you can maximize your vehicle’s potential.
What You Will Need
- Purge Two-Step Launch Control Kit
- Basic hand tools (screwdriver, wrench set)
- Wire strippers and connectors
- Electrical tape
- Multimeter
- Safety goggles
Preparation Steps
Before you start the installation process, it’s essential to prepare your workspace and gather all necessary tools. Make sure your Mustang is parked on a flat surface, and the engine is cool. Safety should always be your top priority.
Step 1: Disconnect the Battery
To prevent any electrical issues or shocks, disconnect the negative terminal of the battery. This will ensure that your vehicle’s electrical system is safe to work on.
Step 2: Locate the Wiring Harness
Next, locate the wiring harness for the ignition system. This is typically found near the engine bay. Ensure you have access to the wires that will be connected to the launch control system.
Installation Steps
Step 3: Mount the Launch Control Unit
Find a suitable location to mount the Purge Two-Step Launch Control unit. It should be easily accessible but also secure from heat and moving parts. Use screws or brackets to secure the unit in place.
Step 4: Connect the Wires
Using the wiring diagram provided with your launch control kit, connect the necessary wires to the ignition harness. Typically, you will connect:
- Power wire to the battery or ignition switch
- Ground wire to a suitable ground point
- Signal wire to the ignition coil
Ensure all connections are secure and insulated with electrical tape to prevent any short circuits.
Step 5: Install the Purge Button
Locate a convenient spot on your dashboard or center console to install the purge button. Drill a hole if necessary, and securely mount the button. Connect the button to the launch control unit as per the instructions.
Final Steps
Step 6: Reconnect the Battery
Once all connections have been made and secured, reconnect the negative terminal of the battery. Ensure everything is tight to avoid any electrical issues.
Step 7: Test the System
Start your Mustang and test the launch control system. Press the purge button to activate the two-step feature. You should hear the engine RPMs drop, indicating the system is functioning correctly.
Step 8: Troubleshooting
If the system does not work as expected, double-check all wiring connections and ensure that the launch control unit is receiving power. Use a multimeter to test the voltage levels.
Conclusion
Installing a Purge Two-Step Launch Control on your Ford Mustang can enhance your drag racing experience. By following this step-by-step guide, you can ensure a successful installation and improved performance on the track.