Table of Contents
Upgrading your 2015 Mustang GT with an AEM Infinity 5060 is an excellent way to enhance its performance. This step-by-step guide will walk you through the installation process, ensuring you achieve optimal results.
Tools and Materials Needed
- AEM Infinity 5060 ECU
- Basic hand tools (screwdrivers, wrenches, etc.)
- Wire strippers and connectors
- Electrical tape
- Multimeter
- Heat shrink tubing
- Zip ties
Preparation
Before starting the installation, ensure your vehicle is parked on a flat surface and the engine is cool. Disconnect the battery to prevent any electrical shorts during the installation process.
Remove the Factory ECU
Locate the factory ECU in your Mustang. It is typically found in the engine bay, near the passenger side. Carefully disconnect the wiring harness and remove any mounting bolts holding the ECU in place.
Install the AEM Infinity 5060
Position the AEM Infinity 5060 in the same location as the factory ECU. Secure it with the mounting bolts and reconnect the wiring harness. Ensure all connections are tight and secure.
Wiring the AEM Infinity 5060
Wiring is a critical step in the installation process. Follow the wiring diagram provided by AEM for your specific model to ensure correct connections.
Connect Power and Ground Wires
Connect the power wire to a switched 12V source and the ground wire to a solid ground point on the chassis. Use a multimeter to verify the connections are secure.
Connect Sensor Wires
Connect the necessary sensor wires, including the throttle position sensor, mass airflow sensor, and any additional sensors required for your setup. Ensure each connection is insulated and secured with electrical tape or heat shrink tubing.
Configuring the AEM Infinity 5060
After installation, configure the AEM Infinity 5060 using the AEM tuning software. This step is crucial to ensure your Mustang performs optimally with the new ECU.
Download and Install AEM Tuning Software
Visit the AEM website to download the latest version of their tuning software. Install the software on your computer and connect the AEM Infinity 5060 using a USB cable.
Upload Base Map
Once connected, upload a base map suitable for your Mustang GT. This map will serve as a starting point for your tuning process.
Testing the Installation
After completing the installation and configuration, it’s time to test your Mustang. Reconnect the battery and start the engine. Monitor the engine for any unusual sounds or warning lights.
Perform a Test Drive
Take your Mustang for a test drive to evaluate the performance of the AEM Infinity 5060. Pay attention to throttle response, acceleration, and overall drivability.
Troubleshooting Common Issues
If you encounter any issues during or after installation, refer to the following troubleshooting tips:
- Check all wiring connections for security.
- Ensure the correct base map is uploaded.
- Verify power and ground connections with a multimeter.
Conclusion
Installing an AEM Infinity 5060 on your 2015 Mustang GT can significantly enhance its performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved tuning capabilities.