Table of Contents
Upgrading your Mustang GT with a Borla 3-inch turbo-back exhaust can significantly enhance performance and sound. This step-by-step guide will walk you through the installation process, ensuring you achieve the best results with your vehicle.
Tools and Materials Needed
- Borla 3-inch turbo-back exhaust kit
- Jack and jack stands
- Socket set
- Wrenches
- Torque wrench
- Cutting tool (if necessary)
- Rubber mallet
- Safety glasses
- Gloves
Preparation
Before starting the installation, ensure you have all the necessary tools and materials. It’s also important to work in a well-ventilated area and wear appropriate safety gear.
Step 1: Lift the Vehicle
Begin by using a jack to lift the Mustang GT. Secure it with jack stands to ensure stability while you work underneath the vehicle.
Step 2: Remove the Stock Exhaust System
Locate the stock exhaust system. Use your socket set to remove the bolts securing the exhaust to the catalytic converter and any hangers holding it in place. Carefully detach the exhaust system from the vehicle.
Step 3: Prepare for Installation
Once the stock exhaust is removed, inspect the mounting points and clean any debris or rust. This will ensure a proper fit for the new exhaust system.
Step 4: Install the Borla Exhaust System
Begin by fitting the new Borla exhaust components together. Start with the mid-pipe and connect it to the catalytic converter. Make sure to use the provided gaskets for a secure seal.
Connecting the Mufflers
Next, attach the mufflers to the mid-pipe. Ensure that the hangers are properly aligned and the exhaust is positioned correctly. Use a rubber mallet if necessary to gently tap the components into place.
Step 5: Secure the Exhaust System
Once all components are in place, use your torque wrench to tighten all bolts to the manufacturer’s specifications. This step is crucial to prevent any leaks or loose fittings.
Step 6: Recheck Connections
After securing the exhaust system, double-check all connections and ensure that everything is tight. Make sure that the exhaust does not touch any other components of the vehicle.
Step 7: Lower the Vehicle
Carefully remove the jack stands and lower the Mustang GT back to the ground. Ensure that the exhaust system is clear of any obstacles and properly aligned.
Step 8: Test the Exhaust System
Start the engine and listen for any unusual sounds. Check for leaks around the connections. If everything sounds good, take the vehicle for a short test drive to ensure the exhaust performs well.
Conclusion
Installing a Borla 3-inch turbo-back exhaust on your Mustang GT can greatly enhance its performance and sound. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of your upgraded exhaust system.