Table of Contents
Installing a Borla Cat-back exhaust on your Honda Accord V6 can greatly enhance performance and sound. This step-by-step guide will walk you through the installation process, ensuring you achieve the best results while enjoying the benefits of an upgraded exhaust system.
Tools and Materials Needed
- Jack and jack stands
- Socket set
- Wrench set
- Torque wrench
- Safety glasses
- Gloves
- Borla Cat-back exhaust system
- Rubber mallet
- Cutting tool (if necessary)
Preparation Steps
Before starting the installation, ensure your vehicle is parked on a flat surface and the engine is cool. Gather all necessary tools and materials to avoid interruptions during the process.
Safety First
Wear safety glasses and gloves throughout the installation to protect yourself from debris and sharp edges.
Step-by-Step Installation
Step 1: Lift the Vehicle
Using a jack, lift the rear of your Honda Accord and secure it with jack stands. Make sure the vehicle is stable before proceeding.
Step 2: Remove the Stock Exhaust
Locate the stock exhaust system. Use a socket set to remove the bolts connecting the exhaust to the catalytic converter and the hangers supporting it. If necessary, use a cutting tool to separate the exhaust if it is rusted or stuck.
Step 3: Prepare the New Borla Exhaust
Unbox the Borla Cat-back exhaust system and lay out all components. Familiarize yourself with the parts and their placement according to the provided instructions.
Step 4: Install the New Exhaust System
Begin by attaching the new exhaust pipes to the catalytic converter. Align the pipes and secure them with the provided clamps. Make sure to tighten the bolts to the manufacturer’s specifications using a torque wrench.
Step 5: Hang the Exhaust
Next, hang the exhaust using the rubber hangers. Ensure that the exhaust is positioned correctly and does not interfere with any moving parts of the vehicle.
Step 6: Final Adjustments
Check all connections and ensure everything is tight and secure. Make any necessary adjustments to the positioning of the exhaust system.
Step 7: Lower the Vehicle
Carefully lower the vehicle back to the ground using the jack. Remove the jack stands and ensure the vehicle is stable.
Post-Installation Checks
After installation, start the engine and listen for any unusual noises. Check for leaks around the connections and ensure the exhaust is functioning properly.
Conclusion
Installing a Borla Cat-back exhaust on your Honda Accord V6 can enhance both performance and aesthetics. Following this step-by-step guide will help you complete the installation successfully, allowing you to enjoy the benefits of your new exhaust system.