Table of Contents
Installing a Borla S-type Turbo-back exhaust on your Dodge Ram 1500 can significantly enhance its performance and sound. This step-by-step tutorial will guide you through the installation process to ensure you achieve the best results.
Tools and Materials Needed
- Borla S-type Turbo-back exhaust kit
- Socket set
- Wrench set
- Jack and jack stands
- Safety glasses
- Gloves
- Torque wrench
- Cutting tool (if necessary)
Preparation
Before starting the installation, make sure your vehicle is parked on a level surface. Engage the parking brake and wear safety glasses and gloves to protect yourself during the process.
1. Gather Your Tools and Materials
Collect all the necessary tools and the Borla S-type Turbo-back exhaust kit. Ensure you have everything within reach to streamline the installation process.
2. Lift the Vehicle
Using a jack, lift the rear of your Dodge Ram 1500 and secure it with jack stands. This will provide you with enough space to work comfortably underneath the vehicle.
Removing the Stock Exhaust
The next step is to remove the stock exhaust system. Follow these instructions carefully to avoid any damage to your vehicle.
1. Locate the Exhaust Components
Identify the various components of the stock exhaust system, including the muffler, tailpipe, and any clamps or hangers securing them.
2. Disconnect the Exhaust System
Using your socket set, loosen and remove the bolts securing the exhaust system to the exhaust manifold and catalytic converter. Be cautious of any rust or corrosion that may make this step more difficult.
3. Remove Clamps and Hangers
Remove any clamps and hangers holding the stock exhaust in place. You may need to use a cutting tool if the hangers are rusted or difficult to remove.
4. Take Out the Stock Exhaust
Carefully slide the stock exhaust system out from under the vehicle. Be mindful of any sharp edges or heavy components.
Installing the Borla S-type Turbo-back Exhaust
Now that the stock exhaust is removed, it’s time to install the Borla S-type Turbo-back exhaust. Follow these steps for a successful installation.
1. Position the New Exhaust Components
Begin by positioning the new exhaust components under the vehicle. Start with the front pipe, then the muffler, and finally the tailpipe. Ensure everything is aligned correctly.
2. Connect the Exhaust to the Catalytic Converter
Attach the front pipe to the catalytic converter using the provided clamps and bolts. Tighten them securely, but be careful not to overtighten and damage the components.
3. Install the Muffler
Next, install the muffler by sliding it onto the front pipe. Use the provided hangers to secure it in place. Make sure it is positioned correctly to avoid any contact with other components.
4. Attach the Tailpipe
Attach the tailpipe to the muffler, ensuring it is properly aligned. Secure it with the provided clamps and hangers.
5. Double-check All Connections
Before lowering the vehicle, double-check all connections to ensure they are secure. This includes checking the clamps and hangers for tightness.
Final Steps
After installation, it’s important to perform a few final checks to ensure everything is in order.
1. Lower the Vehicle
Carefully lower the vehicle back to the ground using the jack. Remove the jack stands and ensure everything is stable.
2. Start the Engine
Start the engine and listen for any unusual noises. Ensure that the exhaust is functioning properly and that there are no leaks.
3. Take a Test Drive
Take your Dodge Ram 1500 for a test drive to experience the improved sound and performance. Pay attention to any vibrations or noises that may indicate a problem.
Conclusion
Installing a Borla S-type Turbo-back exhaust on your Dodge Ram 1500 can enhance both performance and sound. By following this step-by-step tutorial, you can ensure a successful installation and enjoy the benefits of your new exhaust system.