Table of Contents
Installing a Cobb Short Throw Shifter can greatly enhance your driving experience by providing quicker and more precise shifts. This guide will take you through the step-by-step process to install your new shifter efficiently and effectively.
Tools and Materials Needed
- Cobb Short Throw Shifter Kit
- Socket Set
- Ratchet
- Torque Wrench
- Flathead Screwdriver
- Phillips Screwdriver
- Needle Nose Pliers
- Shop Towels
- Safety Glasses
Preparation Steps
Before starting the installation, ensure your vehicle is parked on a flat surface and the engine is off. It’s also advisable to wear safety glasses to protect your eyes from any debris.
1. Gather Your Tools
Collect all the necessary tools and materials listed above. This will help streamline the installation process and prevent interruptions.
2. Remove the Shift Knob
To begin, carefully remove the shift knob from the shifter. This may require twisting or pulling, depending on your vehicle model. Use a flathead screwdriver if necessary to assist in the removal.
3. Remove the Center Console Trim
Next, you will need to remove the center console trim. This can usually be done by unscrewing a few screws and gently prying it up. Be cautious not to damage any clips or connectors during this process.
Installing the Cobb Short Throw Shifter
4. Disconnect the Shifter Linkage
Once the trim is removed, locate the shifter linkage. Use your needle nose pliers to disconnect the linkage from the shifter. This may involve removing a clip or pin, so be sure to keep all parts together for reassembly.
5. Remove the Stock Shifter
With the linkage disconnected, you can now remove the stock shifter. This typically involves unscrewing bolts that secure the shifter to the transmission. Use your socket set and ratchet for this task.
6. Install the Cobb Short Throw Shifter
Take your new Cobb Short Throw Shifter and position it where the stock shifter was located. Secure it with the bolts you previously removed, ensuring a snug fit.
7. Reconnect the Shifter Linkage
Reconnect the shifter linkage to the new shifter. Make sure to reinsert any clips or pins that were removed during disassembly.
Final Steps
8. Reinstall the Center Console Trim
Once the shifter is securely in place, carefully reinstall the center console trim. Ensure all clips and screws are properly secured.
9. Reattach the Shift Knob
Finally, reattach the shift knob to the new shifter. Ensure it is firmly in place for optimal performance.
10. Test the Shifter
Before taking your vehicle for a drive, test the shifter to ensure it operates smoothly. Shift through all gears to confirm everything is functioning correctly.
Conclusion
Installing a Cobb Short Throw Shifter can significantly enhance your driving experience. By following these steps, you can ensure a precise shift and improved performance. Enjoy your new shifter!