Installing a Cvf Racing Carbon Fiber Driveshaft on Your Mustang: Step-by-step Guide

by

Installing a CVF Racing Carbon Fiber Driveshaft on your Mustang can significantly enhance performance and reduce weight. This step-by-step guide will walk you through the installation process, ensuring a smooth upgrade to your vehicle.

Tools and Materials Needed

  • Socket set
  • Wrench set
  • Torque wrench
  • Jack and jack stands
  • Safety glasses
  • CVF Racing Carbon Fiber Driveshaft
  • Grease

Preparation Steps

Before starting the installation, ensure that you have all necessary tools and materials ready. Follow these preparation steps:

  • Park your Mustang on a level surface.
  • Engage the parking brake.
  • Disconnect the battery to avoid any electrical issues.

Removing the Stock Driveshaft

To install the CVF Racing Driveshaft, you must first remove the stock driveshaft. Follow these steps:

  • Lift the rear of the Mustang using a jack and secure it with jack stands.
  • Locate the stock driveshaft under the vehicle.
  • Remove the bolts connecting the driveshaft to the differential and transmission using a socket set.
  • Carefully slide the driveshaft out of the transmission and differential.

Preparing the CVF Racing Driveshaft

With the stock driveshaft removed, it’s time to prepare the CVF Racing Driveshaft for installation:

  • Inspect the new driveshaft for any damage.
  • Apply a thin layer of grease to the yoke and splines for smooth installation.

Installing the CVF Racing Driveshaft

Now, you can install the CVF Racing Driveshaft. Follow these steps carefully:

  • Align the driveshaft with the transmission and differential.
  • Slide the driveshaft into the transmission first, ensuring it fits snugly.
  • Insert the driveshaft into the differential, making sure it is properly seated.
  • Secure the driveshaft by tightening the bolts at both ends using a torque wrench to the manufacturer’s specifications.

Final Checks

Once the driveshaft is installed, perform the following final checks:

  • Double-check all bolts for proper torque.
  • Inspect the driveshaft for any clearance issues.
  • Reconnect the battery.

Testing Your Mustang

After installation, it’s essential to test your Mustang to ensure everything is working correctly:

  • Start the vehicle and listen for any unusual noises.
  • Take your Mustang for a short drive, paying attention to vibrations.
  • If everything feels good, you have successfully installed your new driveshaft!

Conclusion

Installing a CVF Racing Carbon Fiber Driveshaft on your Mustang is a straightforward process that can enhance your vehicle’s performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of your new driveshaft.