Table of Contents
Upgrading your Chevy Nova with an Edelbrock Performer Intake can significantly enhance its performance. This step-by-step guide will walk you through the installation process, ensuring you achieve optimal results while boosting your engine’s capabilities.
Tools and Materials Required
- Edelbrock Performer Intake manifold
- Gasket set
- Torque wrench
- Socket set
- Ratchet
- Engine oil
- Cleaning supplies
- Rags
Before starting the installation, gather all necessary tools and materials. Having everything ready will streamline the process and minimize downtime.
Preparation Steps
Begin by preparing your workspace and the vehicle. Follow these steps to ensure a smooth installation:
- Park the Chevy Nova on a flat surface and engage the parking brake.
- Disconnect the battery to avoid any electrical issues during installation.
- Remove any components obstructing access to the intake manifold, such as the air cleaner, throttle linkage, and vacuum hoses.
Removing the Old Intake Manifold
With the workspace prepared, it’s time to remove the old intake manifold. Follow these steps carefully:
- Remove the bolts securing the old intake manifold using a socket set.
- Carefully lift the old manifold off the engine, taking care not to damage any surrounding components.
- Inspect the old gaskets and clean the mating surfaces on the engine block using a scraper and cleaning supplies.
Installing the Edelbrock Performer Intake
Now that the old intake is removed, it’s time to install the new Edelbrock Performer Intake. Follow these steps for a successful installation:
- Place the new gaskets onto the engine block, ensuring proper alignment with the intake ports.
- Carefully position the Edelbrock Performer Intake onto the gaskets, ensuring it sits evenly.
- Install the intake manifold bolts by hand to avoid cross-threading.
- Use a torque wrench to tighten the bolts to the manufacturer’s specifications, typically starting from the center and working outward.
Reconnecting Components
With the new intake manifold securely in place, it’s time to reconnect all previously removed components. Follow these steps:
- Reconnect the throttle linkage and any vacuum hoses that were previously disconnected.
- Reinstall the air cleaner and ensure all fasteners are tightened.
- Double-check all connections for proper fit and security.
Final Steps
After everything is reconnected, perform the following final steps to complete the installation:
- Reconnect the battery and ensure all electrical connections are secure.
- Start the engine and let it idle for a few minutes, checking for any leaks or unusual noises.
- Take the vehicle for a short test drive to assess performance improvements.
Conclusion
Installing an Edelbrock Performer Intake on your Chevy Nova can provide a noticeable boost in performance. By following these step-by-step instructions, you can successfully complete the installation and enjoy the enhanced capabilities of your vehicle.