Installing a Edelbrock Performer Rpm Cam in Your Tri-five Chevy: Step-by-step Guide

by

Installing a Edelbrock Performer RPM Cam in Your Tri-Five Chevy: Step-by-Step Guide

The Tri-Five Chevy, known for its classic design and performance potential, is a favorite among car enthusiasts. Upgrading to an Edelbrock Performer RPM Cam can significantly enhance your engine’s performance. This guide will walk you through the installation process step-by-step.

Tools and Materials Needed

  • Edelbrock Performer RPM Cam kit
  • Socket set
  • Wrench set
  • Screwdrivers
  • Torque wrench
  • Engine oil
  • Camshaft lubricant
  • Timing chain cover gasket
  • Intake manifold gasket
  • Clean rags

Preparation Steps

Before starting the installation, ensure that you have a clean workspace and all necessary tools and materials at hand. Follow these steps to prepare your Tri-Five Chevy:

  • Disconnect the battery to avoid any electrical issues.
  • Remove the air cleaner and intake manifold.
  • Drain the engine oil to prevent spills during camshaft removal.
  • Remove the timing chain cover.

Removing the Old Camshaft

With the preparation complete, you can now remove the old camshaft. Follow these steps:

  • Remove the valve covers to access the rocker arms.
  • Detach the rocker arms and pushrods, noting their positions for reinstallation.
  • Remove the timing chain from the camshaft gear.
  • Unbolt the camshaft from the engine block.
  • Carefully slide the old camshaft out of the engine.

Installing the Edelbrock Performer RPM Cam

Now that the old camshaft is removed, you can install the new Edelbrock Performer RPM Cam:

  • Apply camshaft lubricant to the new camshaft.
  • Carefully insert the new camshaft into the engine, ensuring it aligns with the cam bearings.
  • Secure the camshaft to the engine block using the bolts.
  • Reattach the timing chain to the camshaft gear.
  • Reinstall the pushrods and rocker arms in their original positions.

Reassembling the Engine

Once the new camshaft is installed, it’s time to reassemble the engine:

  • Replace the timing chain cover with a new gasket.
  • Reinstall the intake manifold with a new gasket.
  • Reattach the valve covers.
  • Fill the engine with fresh oil.
  • Reconnect the battery.

Final Checks and Testing

After reassembling the engine, perform the following final checks before starting the vehicle:

  • Check for any loose bolts or components.
  • Ensure all connections are secure.
  • Inspect for any oil leaks around the gaskets.
  • Start the engine and listen for any unusual noises.
  • Allow the engine to reach operating temperature and check the oil pressure.

Conclusion

Installing an Edelbrock Performer RPM Cam in your Tri-Five Chevy can greatly enhance its performance and driving experience. By following this step-by-step guide, you can successfully complete the installation and enjoy the benefits of your upgraded engine.