Table of Contents
The Garrett GTX3584RS turbocharger is a popular upgrade for the Mazda 13B-REW engine, known for its ability to significantly increase power output and performance. This guide will walk you through the installation process step-by-step and discuss the power expectations you can anticipate after the upgrade.
Tools and Materials Needed
- Garrett GTX3584RS turbocharger
- Turbo manifold
- Oil feed and drain lines
- Intercooler piping
- Boost controller
- Fuel injectors
- ECU tuning software
- Basic hand tools (sockets, wrenches, etc.)
- Torque wrench
- Gaskets and seals
Preparation Steps
Before starting the installation, ensure that you have a clean workspace and all necessary tools and materials on hand. It is also advisable to review the vehicle’s manual and familiarize yourself with the 13B-REW engine layout.
Removing the Old Turbocharger
1. Begin by disconnecting the battery to prevent any electrical issues.
2. Remove any engine covers or components obstructing access to the turbocharger.
3. Disconnect the intake and exhaust piping from the existing turbocharger.
4. Remove the oil feed and drain lines connected to the old turbo.
5. Unbolt the turbocharger from the manifold and carefully lift it out of the engine bay.
Installing the Garrett GTX3584RS
1. Place the new turbocharger onto the turbo manifold, ensuring proper alignment with the mounting holes.
2. Secure the turbocharger with the appropriate bolts, tightening them to the manufacturer’s specifications using a torque wrench.
3. Connect the oil feed and drain lines, ensuring that they are properly sealed to prevent leaks.
4. Reattach the intake and exhaust piping to the turbocharger, ensuring all clamps are tight.
Intercooler and Piping Installation
1. Install the intercooler in a suitable location, ensuring adequate airflow.
2. Connect the intercooler piping to the turbocharger and throttle body, securing all connections with clamps.
Fuel System Upgrade
1. Upgrade the fuel injectors to accommodate the increased air flow and power expectations.
2. Ensure that the fuel pump is capable of providing sufficient fuel pressure for the new setup.
ECU Tuning
1. Use ECU tuning software to adjust fuel maps and boost control settings to optimize performance.
2. Consider consulting a professional tuner for best results.
Power Expectations
When properly installed and tuned, the Garrett GTX3584RS can significantly enhance the performance of the 13B-REW engine. Here are some power expectations:
- Potential power output of 400-500 horsepower depending on supporting modifications.
- Improved throttle response and acceleration.
- Enhanced torque curve, providing better drivability.
Conclusion
Installing a Garrett GTX3584RS on a 13B-REW engine can yield impressive performance gains. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of increased power and efficiency. Always remember to tune your engine properly to achieve the best results and maintain reliability.