Installing a Gatortorque 3500 Stall Converter: Step-by-step Guide and Tips

by

Installing a GatorTorque 3500 Stall Converter can significantly enhance your vehicle’s performance. This guide will walk you through the installation process step-by-step, ensuring you have the necessary information to complete the task successfully.

Tools and Materials Needed

  • GatorTorque 3500 Stall Converter
  • Socket set
  • Torque wrench
  • Transmission fluid
  • Jack and jack stands
  • Safety glasses
  • Shop towels

Before starting the installation, gather all the necessary tools and materials. Having everything on hand will make the process smoother and more efficient.

Preparation Steps

Before you begin the installation, it’s important to prepare your vehicle properly. Follow these preparation steps:

  • Ensure the vehicle is parked on a level surface.
  • Disconnect the battery to prevent any electrical issues.
  • Raise the vehicle using a jack and secure it with jack stands.
  • Drain the transmission fluid if necessary.

Removing the Old Converter

To install the new GatorTorque 3500 Stall Converter, you must first remove the old converter. Here’s how:

  • Locate the transmission access panel under the vehicle.
  • Remove the bolts securing the old converter to the flexplate.
  • Carefully slide the old converter out of the transmission.
  • Inspect the old converter for any signs of damage.

Installing the GatorTorque 3500 Stall Converter

Now that the old converter is removed, you can install the GatorTorque 3500 Stall Converter. Follow these steps:

  • Align the new converter with the transmission input shaft.
  • Push the converter into the transmission until it is fully seated.
  • Rotate the converter to ensure it engages with the pump inside the transmission.
  • Secure the converter to the flexplate using the provided bolts.

Reconnecting Components

Once the new converter is installed, reconnect all components that were removed during the process:

  • Reattach the transmission access panel.
  • Reconnect any electrical connectors that were disconnected.
  • Ensure all bolts are tightened to the manufacturer’s specifications.

Filling the Transmission with Fluid

After reassembling the components, it’s time to fill the transmission with fluid:

  • Locate the transmission dipstick tube.
  • Add the appropriate type and amount of transmission fluid.
  • Start the engine and let it idle for a few minutes.
  • Check the fluid level and add more if necessary.

Final Checks and Testing

Before taking your vehicle for a drive, perform the following final checks:

  • Inspect for any leaks around the transmission and converter.
  • Ensure all tools are removed from the engine bay.
  • Take the vehicle for a test drive to check the performance of the new converter.

Tips for a Successful Installation

Here are some tips to ensure a successful installation of your GatorTorque 3500 Stall Converter:

  • Read the manufacturer’s instructions thoroughly before starting.
  • Have a helper if possible to make the process easier.
  • Take your time and don’t rush through the installation.
  • Double-check all connections and fluid levels before driving.

Conclusion

Installing a GatorTorque 3500 Stall Converter can improve your vehicle’s performance significantly. By following this step-by-step guide, you can ensure a successful installation. Remember to take your time and follow all safety precautions throughout the process.