Installing a Greddy E-manage Ultimate on Your 2g Eclipse: a Comprehensive Step-by-step Guide ($400)

by

Installing a Greddy E-manage Ultimate on your 2G Eclipse can significantly enhance the performance of your vehicle. This comprehensive step-by-step guide will walk you through the entire process, ensuring a successful installation for around $400.

What You Will Need

  • Greddy E-manage Ultimate unit
  • Wiring harness
  • Basic hand tools (screwdrivers, wrenches, etc.)
  • Socket set
  • Electrical tape
  • Wire strippers and connectors
  • Multimeter
  • Computer with E-manage software

Preparation Steps

Before starting the installation, ensure that you have all the necessary tools and components. Here are some preparation steps to follow:

  • Disconnect the battery to prevent any electrical shorts.
  • Gather all tools and components in a clean workspace.
  • Read the Greddy E-manage Ultimate manual thoroughly.

Step 1: Access the ECU

To install the E-manage, you need to access the vehicle’s ECU. Follow these steps:

  • Locate the ECU, which is typically found under the passenger side dashboard.
  • Remove the screws or clips securing the ECU cover.
  • Carefully unplug the ECU connectors.

Step 2: Connect the E-manage Wiring Harness

Once you have access to the ECU, it’s time to connect the E-manage wiring harness:

  • Identify the wires on the E-manage wiring harness.
  • Follow the wiring diagram provided by Greddy to connect the harness to the ECU.
  • Use wire strippers and connectors to secure the connections.
  • Wrap connections with electrical tape for insulation.

Step 3: Mount the E-manage Unit

After connecting the wiring harness, you need to mount the E-manage unit:

  • Choose a suitable location for the E-manage unit, preferably in the cabin for easy access.
  • Use screws or adhesive mounts to secure the unit in place.
  • Ensure that the unit is not obstructed and has adequate ventilation.

Step 4: Reconnect the Battery and Test the System

With everything connected, it’s time to test the system:

  • Reconnect the battery terminals.
  • Turn the ignition to the ON position without starting the engine.
  • Check for any warning lights on the dashboard.
  • Use the E-manage software on your computer to ensure the unit is communicating with the vehicle.

Step 5: Tune the E-manage

After confirming that the E-manage is functioning correctly, you can proceed to tune the system:

  • Connect your computer to the E-manage unit via USB.
  • Open the E-manage software and select the appropriate settings for your vehicle.
  • Adjust fuel maps, ignition timing, and other parameters as needed.
  • Save your settings and upload them to the E-manage unit.

Step 6: Final Checks and Testing

Once tuning is complete, perform final checks:

  • Double-check all wiring connections for security.
  • Start the engine and listen for any unusual sounds.
  • Take the vehicle for a test drive to ensure everything is functioning as expected.

Conclusion

Installing a Greddy E-manage Ultimate on your 2G Eclipse can be a rewarding project that enhances your vehicle’s performance. By following this comprehensive guide, you can successfully complete the installation and tuning process, all within a budget of $400.