Table of Contents
Upgrading your Audi TTRS with a high-flow intake system can significantly enhance engine performance, yielding gains of 20+ horsepower. This guide provides a step-by-step approach to installing a high-flow intake, ensuring you maximize your vehicle’s potential.
Understanding the Benefits of a High-Flow Intake
A high-flow intake system allows for improved airflow to the engine, which can lead to several benefits:
- Increased horsepower and torque
- Improved throttle response
- Enhanced engine sound
- Better fuel efficiency
Tools and Materials Needed
Before starting the installation, ensure you have the following tools and materials:
- High-flow intake kit
- Socket set
- Screwdrivers (flathead and Phillips)
- Torque wrench
- Rubber gloves
- Shop towels
Step-by-Step Installation Guide
Step 1: Prepare Your Vehicle
Park your Audi TTRS on a flat surface and engage the parking brake. Open the hood and allow the engine to cool down completely before proceeding.
Step 2: Remove the Stock Intake System
Begin by disconnecting the negative battery terminal to prevent any electrical issues. Next, locate the stock intake system:
- Unclip the airbox cover and remove it.
- Disconnect the mass airflow sensor (MAF) connector.
- Loosen the clamps securing the intake hose and remove the hose.
- Unscrew any bolts holding the airbox in place and lift it out.
Step 3: Install the High-Flow Intake
With the stock intake removed, it’s time to install the high-flow intake:
- Position the new intake tube in place.
- Secure the intake tube with the provided clamps.
- Reconnect the MAF sensor to the new intake.
- Ensure all connections are tight and secure.
Step 4: Reassemble and Test
After installing the high-flow intake, reassemble any components you removed:
- Replace the airbox cover.
- Reconnect the negative battery terminal.
- Start the engine and let it idle for a few minutes.
Post-Installation Tips
After installing your high-flow intake, consider the following:
- Monitor engine performance for any irregularities.
- Check for any leaks in the intake system.
- Consider a tune to fully optimize performance gains.
Conclusion
Installing a high-flow intake on your Audi TTRS is a straightforward process that can lead to significant performance improvements. With careful preparation and attention to detail, you can enjoy the enhanced power and responsiveness of your vehicle.