Table of Contents
The Mitsubishi 3000GT is a beloved sports car, known for its performance and style. One of the best ways to enhance its power and efficiency is by installing a high-quality intake system. In this guide, we will walk you through the step-by-step process of installing the HKS Super Power Flow Intake on your Mitsubishi 3000GT.
Tools and Materials Needed
- HKS Super Power Flow Intake Kit
- Socket set
- Wrench set
- Screwdriver set
- Rubber grommets (if needed)
- Shop towels
- Safety glasses
- Gloves
Preparation
Before starting the installation, ensure you have all the necessary tools and materials ready. It’s also important to work in a well-ventilated area and wear safety gear such as gloves and safety glasses.
Step 1: Remove the Stock Air Intake
Begin by opening the hood of your Mitsubishi 3000GT. Locate the stock air intake system, which is typically found on the driver’s side of the engine bay. Use your socket set to remove the bolts securing the air intake assembly.
Next, disconnect any hoses or clamps attached to the stock intake. Carefully pull the intake out of the engine bay, taking care not to damage any surrounding components.
Step 2: Prepare the HKS Super Power Flow Intake
Unbox the HKS Super Power Flow Intake kit and lay out all components. Familiarize yourself with the parts, including the intake pipe, filter, and any necessary fittings. If your kit includes rubber grommets, ensure they are in good condition and ready for installation.
Step 3: Install the HKS Intake Pipe
Begin the installation by attaching the HKS intake pipe to the throttle body. Align the pipe properly and secure it using the provided clamps. Make sure the connection is tight to prevent any air leaks.
Step 4: Attach the HKS Air Filter
Once the intake pipe is securely in place, it’s time to attach the HKS air filter. Slide the filter onto the end of the intake pipe and secure it with the provided clamp. Ensure the filter is fitted snugly to prevent any debris from entering the engine.
Step 5: Reconnect Hoses and Clamps
After the intake and filter are installed, reconnect any hoses or clamps that were detached during the removal of the stock intake. Double-check all connections to ensure they are secure.
Step 6: Final Checks
Before closing the hood, take a moment to inspect the installation. Ensure that the HKS intake system is properly aligned and that all clamps and connections are tight. Look for any signs of wear or damage that may need addressing.
Step 7: Start the Engine
With everything in place, start your Mitsubishi 3000GT and listen for any unusual noises. The engine should run smoothly. If you notice any issues, double-check your installation to ensure everything is secure.
Step 8: Test Drive
After confirming that the installation is successful, take your 3000GT for a test drive. Pay attention to the engine’s performance and throttle response. You should notice an improvement in power and acceleration due to the enhanced airflow from the HKS Super Power Flow Intake.
Maintenance Tips
To keep your HKS intake system functioning optimally, follow these maintenance tips:
- Regularly check and clean the air filter according to the manufacturer’s recommendations.
- Inspect all connections and clamps periodically to ensure they remain tight.
- Monitor engine performance and address any issues promptly.
Conclusion
Installing the HKS Super Power Flow Intake on your Mitsubishi 3000GT is a straightforward process that can significantly enhance your vehicle’s performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved airflow and engine efficiency.