Table of Contents
Installing a JBA Long Tube Header on your Tahoe 6.2 can significantly enhance performance, providing gains of 15-20 horsepower. This article will guide you through the costs, steps, and benefits of this upgrade.
Understanding Long Tube Headers
Long tube headers are designed to improve exhaust flow, which can lead to increased horsepower and torque. They replace the factory exhaust manifolds and are typically more efficient in directing exhaust gases out of the engine.
Benefits of Installing JBA Long Tube Headers
- Increased Horsepower: Expect gains of 15-20 HP.
- Improved Torque: Enhanced low-end torque for better acceleration.
- Better Exhaust Sound: A deeper and more aggressive exhaust note.
- Enhanced Performance: Overall better engine performance and efficiency.
Cost of JBA Long Tube Headers
The cost of JBA Long Tube Headers varies based on several factors including location and installation method. Here’s a breakdown of potential expenses:
- Headers Cost: Approximately $800 – $1,200.
- Installation Cost: $300 – $600 if done by a professional.
- Additional Parts: $100 – $300 for gaskets and other necessary components.
Tools Required for Installation
- Socket Set
- Torque Wrench
- Wrenches
- Jack and Jack Stands
- Exhaust Hanger Tool
- Safety Glasses
- Gloves
Steps to Install JBA Long Tube Headers
Step 1: Prepare the Vehicle
Start by parking the vehicle on a flat surface and engaging the parking brake. Disconnect the battery to ensure safety during installation.
Step 2: Lift the Vehicle
Using a jack, lift the vehicle and secure it with jack stands. This will provide adequate space to work underneath the Tahoe.
Step 3: Remove the Old Exhaust Manifolds
Unbolt the factory exhaust manifolds from the engine. You may need to remove other components such as the heat shield or oxygen sensors to gain access.
Step 4: Install the JBA Long Tube Headers
Position the new headers into place and secure them with bolts. Make sure to use new gaskets to prevent exhaust leaks.
Step 5: Reinstall Other Components
Reinstall any components that were removed during the process, such as oxygen sensors and heat shields. Ensure everything is tightened properly.
Step 6: Lower the Vehicle and Reconnect the Battery
Carefully lower the vehicle back to the ground. Reconnect the battery and check for any leaks or issues.
Final Thoughts
Installing JBA Long Tube Headers on your Tahoe 6.2 is a rewarding upgrade that can significantly enhance performance. With the right tools and steps, you can achieve better horsepower and torque, making your driving experience more enjoyable.