Table of Contents
Installing a Kelford camshaft on your AE86 can significantly enhance your vehicle’s performance. This article will guide you through the power gains you can expect and provide essential tips for a successful installation.
Understanding the Kelford Camshaft
Kelford camshafts are renowned for their quality and performance improvements. They are designed to optimize engine efficiency and increase power output, making them a popular choice among AE86 enthusiasts.
- Improved throttle response
- Higher horsepower and torque
- Better overall engine performance
Power Gains from a Kelford Camshaft
When you install a Kelford camshaft, you can expect notable power gains. The extent of these gains can depend on various factors, including your engine setup and tuning.
Expected Power Improvements
Typically, users report an increase in horsepower ranging from 10 to 30% after installation. Additionally, torque improvements can enhance the driving experience, especially in mid-range RPMs.
Preparation for Installation
Before diving into the installation process, proper preparation is crucial. Gather all necessary tools and components to ensure a smooth installation.
- Socket set
- Torque wrench
- Camshaft installation tool
- Engine oil
- New gaskets and seals
Step-by-Step Installation Guide
Follow these steps to install your Kelford camshaft successfully:
- Step 1: Disconnect the battery and remove any engine covers.
- Step 2: Drain the engine oil and remove the old camshaft.
- Step 3: Clean the camshaft housing and inspect for wear.
- Step 4: Install the new Kelford camshaft using the installation tool.
- Step 5: Reassemble the engine components and replace gaskets as needed.
- Step 6: Refill the engine with new oil and reconnect the battery.
Tuning Your Engine After Installation
After installing the Kelford camshaft, it is essential to tune your engine for optimal performance. A proper tune can help you take full advantage of the power gains.
- Adjust fuel maps for better air-fuel ratio.
- Optimize ignition timing for improved throttle response.
- Consider a dyno session for precise tuning.
Common Issues and Troubleshooting
While installing a Kelford camshaft is straightforward, some common issues can arise. Being aware of these can save you time and frustration.
- Misalignment during installation can lead to improper timing.
- Using incorrect gaskets may cause oil leaks.
- Failure to properly tune the engine can result in poor performance.
Conclusion
Installing a Kelford camshaft on your AE86 can provide significant power gains and improve your driving experience. By following the proper installation steps and tuning your engine, you can enjoy the full benefits of this upgrade.