Table of Contents
The Ram TRX is a powerful truck, but for enthusiasts looking to enhance its performance, installing a Magnuson TVS2650 supercharger can take it to the next level. This guide will walk you through the step-by-step process of installation and outline the power expectations you can anticipate once the supercharger is in place.
What You Will Need
- Magnuson TVS2650 Supercharger Kit
- Basic hand tools (wrenches, sockets, screwdrivers)
- Torque wrench
- Ratchet and extensions
- Engine oil
- Coolant
- Shop towels
- Safety glasses and gloves
Preparation Steps
Before you start the installation, ensure that you have a clean workspace and all necessary tools at hand. It is also recommended to read through the Magnuson installation manual thoroughly to familiarize yourself with the components and procedures.
Disconnect the Battery
Begin by disconnecting the negative battery terminal to prevent any electrical issues during the installation process.
Remove the Engine Cover
Next, carefully remove the engine cover. This will give you access to the intake manifold and other components that need to be removed for the supercharger installation.
Removing Existing Components
To install the Magnuson supercharger, you will need to remove certain existing components from the engine.
Detach the Intake Manifold
Using your socket set, carefully unbolt the intake manifold from the engine. Make sure to label any connectors or hoses for easier reinstallation.
Remove the Throttle Body
Once the intake manifold is out of the way, detach the throttle body from the manifold. This may require unplugging electrical connectors and removing additional bolts.
Installing the Magnuson TVS2650 Supercharger
With the existing components removed, you can now begin the installation of the Magnuson supercharger.
Mount the Supercharger
Position the Magnuson supercharger onto the engine block, aligning it with the mounting points. Secure it using the provided bolts and a torque wrench, ensuring you follow the specified torque settings in the manual.
Reconnect the Throttle Body
After the supercharger is securely mounted, reconnect the throttle body to the supercharger. Make sure all electrical connectors and hoses are properly attached.
Install the Intake Manifold
Next, reinstall the intake manifold over the supercharger. Ensure that it fits properly and tighten all bolts to the specified torque settings.
Final Steps and Testing
With the supercharger and other components reinstalled, you can now proceed to the final steps.
Refill Fluids
Refill the engine oil and coolant as necessary. Check for any leaks before starting the engine.
Reconnect the Battery
Reconnect the negative battery terminal and ensure everything is secure.
Start the Engine
Start the engine and listen for any unusual noises. Allow the engine to idle for a few minutes to ensure everything is functioning properly.
Power Expectations
After successfully installing the Magnuson TVS2650 supercharger, you can expect a significant increase in power output. Typically, the Ram TRX will see an increase of:
- Horsepower: Up to 700+ hp
- Torque: Increased torque for better acceleration
Conclusion
Installing a Magnuson TVS2650 supercharger on your Ram TRX can dramatically enhance its performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the power boost that comes with it.