Table of Contents
Installing a Mishimoto radiator and upgraded turbolines on your Mitsubishi Evo can significantly enhance performance and cooling efficiency. This step-by-step guide will walk you through the entire process, ensuring that you have a smooth installation experience.
Tools and Materials Needed
- Mishimoto radiator
- Upgraded turbolines
- Socket set
- Wrench set
- Coolant
- Torque wrench
- Drain pan
- Shop towels
- Zip ties
- Safety gloves
- Safety glasses
Preparing for Installation
Before starting the installation, ensure that your vehicle is parked on a flat surface and the engine is cool. Gather all the necessary tools and materials to streamline the process.
Safety Precautions
Always wear safety gloves and glasses when working on your vehicle. Ensure that the engine is off and has cooled down to prevent burns.
Removing the Stock Radiator
To install the Mishimoto radiator, you must first remove the stock radiator. Follow these steps:
- Locate the drain plug at the bottom of the stock radiator and place a drain pan underneath.
- Open the drain plug and allow the coolant to drain completely.
- Disconnect the upper and lower radiator hoses by loosening the clamps with a screwdriver.
- Remove any electrical connectors attached to the radiator fan.
- Unscrew the mounting bolts that secure the radiator in place.
- Carefully lift the radiator out of the engine bay.
Installing the Mishimoto Radiator
Now that the stock radiator is removed, it’s time to install the Mishimoto radiator. Follow these steps:
- Position the Mishimoto radiator into the mounting brackets.
- Secure the radiator with the mounting bolts you removed earlier.
- Reconnect the upper and lower radiator hoses, ensuring the clamps are tight.
- Reconnect any electrical connectors to the radiator fan.
- Double-check all connections and ensure everything is secure.
Installing Upgraded Turbolines
With the Mishimoto radiator installed, you can now proceed to upgrade the turbolines. Here’s how to do it:
- Remove the existing turbolines by disconnecting any electrical connectors and hoses.
- Unscrew the bolts securing the turbolines in place using a socket set.
- Carefully lift the old turbolines out of the engine bay.
- Position the upgraded turbolines into place, ensuring proper alignment.
- Secure the turbolines with the bolts and reconnect all electrical connectors and hoses.
Refilling Coolant
After the installation of the radiator and turbolines, you need to refill the coolant. Follow these steps:
- Locate the coolant reservoir and remove the cap.
- Pour the new coolant into the reservoir until it reaches the recommended level.
- Start the engine and let it idle for a few minutes, checking for leaks.
- Turn off the engine and allow it to cool, then check the coolant level again and top off if necessary.
Final Checks and Testing
Once everything is installed and the coolant is refilled, it’s time for final checks:
- Inspect all connections for any signs of leaks.
- Ensure that the radiator fan is functioning properly.
- Take the vehicle for a short drive to test the performance of the new radiator and turbolines.
- Monitor the temperature gauge to ensure the engine is not overheating.
Conclusion
Installing a Mishimoto radiator and upgraded turbolines on your Mitsubishi Evo can greatly enhance its performance and reliability. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved cooling and power.