Table of Contents
Installing a Perrin Cold Air Intake on your Toyota 86 can significantly enhance your vehicle’s performance by improving airflow to the engine. This step-by-step guide will walk you through the installation process, ensuring that you can complete the task efficiently and effectively.
Tools and Materials Needed
- Perrin Cold Air Intake Kit
- Socket set
- Screwdriver set
- Torque wrench
- Rubber gloves
- Safety glasses
Before starting the installation, ensure that you have all the necessary tools and materials. This will help you avoid interruptions during the process.
Preparation Steps
Before diving into the installation, it’s crucial to prepare your workspace and vehicle.
- Park your Toyota 86 on a flat surface.
- Turn off the engine and allow it to cool down.
- Disconnect the negative battery terminal to prevent any electrical issues.
Following these preparation steps will ensure a safer and smoother installation process.
Removing the Stock Air Intake
The first major step in the installation is to remove the stock air intake system from your Toyota 86.
- Locate the air intake box. It is usually situated near the front of the engine bay.
- Unclip any retaining clips that hold the air intake box in place.
- Disconnect the mass airflow sensor (MAF) connector by pressing the tab and pulling it out.
- Remove the intake duct by loosening the hose clamps with a screwdriver.
- Carefully lift the air intake box out of the engine bay.
Make sure to keep all screws and clips in a safe place for reinstallation if needed.
Installing the Perrin Cold Air Intake
Now that the stock air intake has been removed, it’s time to install the Perrin Cold Air Intake.
- Begin by placing the Perrin air intake box into the designated space in the engine bay.
- Connect the intake duct to the throttle body, ensuring a snug fit.
- Secure the intake duct using the provided hose clamps.
- Reconnect the mass airflow sensor by plugging it back into the connector.
- Ensure all connections are tight and secure to prevent any air leaks.
Following these steps will ensure that the Perrin Cold Air Intake is installed correctly.
Finalizing the Installation
After installing the cold air intake, there are a few final steps to complete the process.
- Recheck all connections and ensure everything is secure.
- Reconnect the negative battery terminal.
- Start the engine and listen for any unusual sounds that may indicate a problem.
- Take the vehicle for a short test drive to ensure everything is functioning properly.
These final steps are crucial to ensure that your new cold air intake is working as intended.
Benefits of Installing a Cold Air Intake
Installing a cold air intake like the Perrin can provide several benefits to your Toyota 86.
- Improved engine performance and horsepower.
- Enhanced throttle response.
- Better fuel efficiency in some cases.
- Distinctive engine sound that enhances driving experience.
These advantages make the installation of a cold air intake a popular modification among car enthusiasts.
Conclusion
Installing a Perrin Cold Air Intake on your Toyota 86 is a straightforward process that can yield significant performance benefits. By following this step-by-step guide, you can ensure a successful installation and enjoy the enhanced driving experience that comes with improved airflow to your engine.