Table of Contents
Installing a ProCharger Stage II supercharger on your Challenger can significantly enhance its performance and power. This guide will take you through the entire process step-by-step, ensuring that you have all the necessary information to complete the installation successfully.
What You Will Need
- ProCharger Stage II Supercharger Kit
- Basic hand tools (sockets, wrenches, etc.)
- Torque wrench
- Jack and jack stands
- Safety glasses and gloves
- Coolant and oil
- Installation manual
Preparation Steps
Before starting the installation, it is crucial to prepare your workspace and gather all necessary tools and components. Make sure your Challenger is parked on a flat surface and the engine is cool.
1. Disconnect the Battery
To ensure safety during the installation, disconnect the negative battery terminal. This will prevent any electrical issues while you work on the vehicle.
2. Raise the Vehicle
Using a jack, raise the front of the vehicle and secure it with jack stands. This will provide easier access to the engine bay and components that need to be removed.
Removing Existing Components
Next, you will need to remove several components to make room for the supercharger installation.
1. Remove the Air Intake
Start by removing the air intake system. This involves disconnecting the intake tube and any sensors attached to it. Set these parts aside for reinstallation later.
2. Remove the Throttle Body
Next, detach the throttle body by unscrewing the bolts that hold it in place. Carefully lift it off and place it in a safe location.
3. Remove the Factory Supercharger (if applicable)
If your Challenger is equipped with a factory supercharger, remove it according to the manufacturer’s instructions. Ensure all connections are undone before lifting it out.
Installing the ProCharger Supercharger
With the existing components removed, you can now begin the installation of the ProCharger Stage II supercharger.
1. Install the Bracket
Start by installing the supercharger mounting bracket. Use the provided bolts and ensure they are torqued to the specifications outlined in the installation manual.
2. Mount the Supercharger
Carefully position the ProCharger supercharger onto the bracket and secure it with the appropriate bolts. Make sure it is aligned correctly before tightening.
3. Reinstall the Throttle Body
After the supercharger is mounted, reinstall the throttle body. Ensure that all bolts are tightened to the correct torque specifications to prevent any air leaks.
4. Connect the Intake System
Reconnect the intake system, ensuring that all hoses and clamps are secure. This includes reattaching any sensors that were previously disconnected.
Final Steps
Once the supercharger is installed, there are a few final steps to complete before you can start your Challenger.
1. Reconnect the Battery
Reconnect the negative terminal of the battery. This will allow you to power up the vehicle and check the new installation.
2. Check Fluid Levels
Ensure that the engine oil and coolant levels are adequate. If necessary, top them off before starting the engine.
3. Start the Engine
Start your Challenger and listen for any unusual sounds. Allow the engine to idle for a few minutes to ensure everything is operating smoothly.
4. Test Drive
Finally, take your Challenger for a test drive. Monitor the performance and check for any issues that may arise during initial use.
Conclusion
Installing a ProCharger Stage II supercharger on your Challenger can be a rewarding project that enhances your vehicle’s performance. By following this step-by-step guide, you should be able to complete the installation with confidence.