Table of Contents
The RSX Type S is known for its impressive performance, but there are always ways to enhance its power. One of the most effective upgrades is installing a Skunk2 Stage 2 Camshaft. This guide will take you through the steps to install this camshaft, helping you unlock more horsepower and torque.
Tools and Materials Needed
- Skunk2 Stage 2 Camshaft
- Socket set
- Torque wrench
- Camshaft installation tool
- Timing belt kit
- Engine oil
- Gasket maker
- Clean rags
- Safety goggles
- Gloves
Preparation
Before starting the installation, make sure your vehicle is parked on a flat surface and the engine is cool. Gather all the tools and materials listed above to ensure a smooth process.
Step 1: Disconnect the Battery
Begin by disconnecting the negative terminal of the battery. This step is crucial for your safety and to prevent any electrical issues while working on the engine.
Step 2: Remove the Engine Cover
Next, remove the engine cover by unscrewing the bolts that hold it in place. Set the cover aside in a safe location.
Step 3: Remove the Timing Belt
To access the camshaft, you need to remove the timing belt. Loosen the tensioner and carefully take off the belt, making sure to note the routing for reinstallation.
Step 4: Remove the Old Camshaft
With the timing belt removed, you can now access the camshaft. Unbolt the camshaft caps and carefully lift the old camshaft out of its position. Be cautious not to drop any components into the engine.
Step 5: Install the Skunk2 Stage 2 Camshaft
Take the Skunk2 Stage 2 Camshaft and align it properly in the engine. Make sure it sits correctly in the bearings. Once in place, reattach the camshaft caps and torque them to the manufacturer’s specifications.
Step 6: Reinstall the Timing Belt
Now that the new camshaft is installed, it’s time to reinstall the timing belt. Follow the original routing you noted earlier, ensuring the belt is tight and properly aligned.
Step 7: Reattach the Engine Cover
With everything back in place, reattach the engine cover. Secure it with the bolts you removed earlier, ensuring it is snug and properly fitted.
Step 8: Reconnect the Battery
Reconnect the negative terminal of the battery. This step completes the installation process, allowing you to power up your vehicle once again.
Step 9: Start the Engine
Start the engine and listen for any unusual noises. Allow the engine to idle for a few minutes, monitoring for any leaks or issues.
Step 10: Test Drive
Finally, take your RSX Type S for a test drive. Pay attention to how the vehicle performs and feel the difference in power. The Skunk2 Stage 2 Camshaft should provide a noticeable improvement in acceleration and responsiveness.
Conclusion
Installing a Skunk2 Stage 2 Camshaft on your RSX Type S is a great way to enhance its performance. By following these steps, you can achieve a successful installation and enjoy the benefits of increased power and torque.