Installing a Tokico Suspension System on the Lexus Rc-f: Step-by-step Guide

by

The Lexus RC-F is a high-performance coupe that combines luxury with speed. One of the most effective upgrades for improving handling and ride quality is installing a Tokico suspension system. This guide will walk you through the step-by-step process of installing this suspension system on your Lexus RC-F.

Tools and Materials Needed

  • Tokico Suspension Kit
  • Jack and Jack Stands
  • Socket Set
  • Wrench Set
  • Torque Wrench
  • Screwdriver Set
  • Spring Compressor
  • Safety Glasses
  • Gloves

Preparation Steps

Before beginning the installation, ensure you have all the necessary tools and materials on hand. Follow these preparation steps:

  • Park the Lexus RC-F on a flat surface.
  • Engage the parking brake.
  • Wear safety glasses and gloves for protection.

Step 1: Lifting the Vehicle

To access the suspension components, you’ll need to lift the vehicle. Follow these steps:

  • Use a jack to lift the front or rear of the vehicle, depending on which suspension you are replacing.
  • Place jack stands under the vehicle for safety.
  • Ensure the vehicle is stable before proceeding.

Step 2: Removing the Old Suspension

Once the vehicle is securely lifted, you can begin removing the old suspension components. Follow these instructions:

  • Start by removing the wheel to access the suspension.
  • Use a wrench to remove the bolts securing the strut to the hub.
  • Disconnect any electrical connectors if applicable.
  • Remove the bolts securing the strut to the vehicle chassis.
  • Carefully take out the old strut and spring assembly.

Step 3: Installing the Tokico Suspension

Now that the old suspension is removed, it’s time to install the Tokico suspension system. Follow these steps:

  • Use a spring compressor to safely compress the new Tokico spring.
  • Install the spring onto the new Tokico strut.
  • Carefully position the strut assembly into the vehicle.
  • Secure the strut to the vehicle chassis using the bolts removed earlier.
  • Reconnect any electrical connectors if applicable.
  • Reattach the strut to the hub with the bolts.

Step 4: Repeating for the Other Side

After completing the installation on one side, repeat the process for the other side of the vehicle. Ensure that both sides are installed correctly for balanced performance.

Step 5: Lowering the Vehicle

Once both sides are installed, it’s time to lower the vehicle back to the ground. Follow these steps:

  • Remove the jack stands carefully.
  • Use the jack to slowly lower the vehicle back to the ground.
  • Reinstall the wheels and tighten the lug nuts securely.

Step 6: Final Checks

After lowering the vehicle, perform the following final checks:

  • Check that all bolts are tightened to the manufacturer’s specifications.
  • Inspect the suspension for any signs of misalignment or damage.
  • Test drive the vehicle to ensure proper handling and comfort.

Conclusion

Installing a Tokico suspension system on your Lexus RC-F can significantly enhance your driving experience. By following this step-by-step guide, you can ensure a successful installation that will improve handling, comfort, and overall performance. Always remember to consult your vehicle’s manual for specific torque specifications and safety guidelines.