Table of Contents
Upgrading the fuel system in your 2G Eclipse is crucial when aiming for high horsepower builds. The Aeromotive fuel pump is a popular choice among enthusiasts looking to support 350+ horsepower without breaking the bank. In this article, we will guide you through the installation process of the Aeromotive fuel pump, ensuring your setup is reliable and efficient.
Why Choose an Aeromotive Fuel Pump?
The Aeromotive fuel pump is known for its durability and performance. Here are some reasons why it’s a great choice for your 2G Eclipse:
- High Flow Rate: Capable of supporting over 350 horsepower.
- Reliability: Designed for continuous duty operation.
- Affordability: Priced around $200, making it accessible for many builders.
Tools and Materials Needed
Before starting the installation, gather the following tools and materials:
- Socket set
- Wrenches
- Screwdrivers
- Wire cutters and strippers
- Electrical tape
- Fuel line and clamps
- Aeromotive fuel pump
- Fuel pump installation kit
Step-by-Step Installation Guide
Step 1: Prepare the Vehicle
Before starting the installation, ensure the vehicle is parked on a flat surface. Disconnect the battery to prevent any electrical issues during the process.
Step 2: Access the Fuel Pump
To access the fuel pump, you will need to remove the rear seat and the access panel. Follow these steps:
- Remove the rear seat by pulling up on the bottom cushion.
- Unscrew the access panel located under the seat.
- Disconnect the fuel lines and electrical connectors from the fuel pump.
Step 3: Remove the Old Fuel Pump
Once you have access to the fuel pump, carefully remove the old unit:
- Unscrew the retaining ring holding the pump in place.
- Lift the old pump out of the tank.
- Inspect the fuel tank for any debris or damage.
Step 4: Install the Aeromotive Fuel Pump
Now it’s time to install the new Aeromotive fuel pump:
- Place the Aeromotive fuel pump into the fuel tank.
- Secure it with the retaining ring.
- Reconnect the electrical connectors and fuel lines.
Step 5: Reassemble the Vehicle
After installing the new pump, reassemble the vehicle:
- Replace the access panel and rear seat.
- Reconnect the battery.
- Check for any leaks by turning the ignition on without starting the engine.
Testing the Installation
Once everything is reassembled, it’s important to test the new fuel pump:
- Start the engine and let it idle.
- Monitor the fuel pressure with a gauge.
- Check for any leaks around the pump and connections.
Conclusion
Installing an Aeromotive fuel pump on your 2G Eclipse is a straightforward process that can significantly enhance your vehicle’s performance. With the right tools and a little patience, you can support your 350+ horsepower build for an affordable price. Enjoy your upgraded fuel system and the power it brings to your driving experience!