Table of Contents
The Toyota 86 is a beloved sports car known for its lightweight design and agile handling. Many enthusiasts look for ways to enhance its performance, and one popular upgrade is the Cobb Accessport. This guide will walk you through the step-by-step process of installing the Cobb Accessport on your Toyota 86, helping you unlock its full potential.
What is the Cobb Accessport?
The Cobb Accessport is a powerful tuning device that allows you to modify your vehicle’s engine management system. It provides a range of features, including:
- Performance Tuning: Adjust fuel maps, ignition timing, and boost levels for improved performance.
- Data Monitoring: Real-time data logging and monitoring of engine parameters.
- Custom Maps: Ability to upload custom tunes created by professional tuners.
Tools Required
Before starting the installation, gather the following tools:
- OBD-II Scanner
- Computer or Laptop
- Cobb Accessport Device
- USB Cable
- Basic Hand Tools (if necessary)
Step-by-Step Installation Guide
Step 1: Prepare Your Vehicle
Before you begin, ensure your Toyota 86 is parked on a flat surface and the ignition is turned off. This will help prevent any electrical issues during the installation process.
Step 2: Connect the Accessport to Your Vehicle
Locate the OBD-II port in your Toyota 86. This port is usually found under the dashboard near the driver’s seat. Plug the Cobb Accessport into the OBD-II port securely.
Step 3: Turn on the Ignition
With the Accessport connected, turn the ignition key to the ON position without starting the engine. This will power up the Accessport and allow it to communicate with the vehicle’s ECU.
Step 4: Install the Cobb Accessport Software
On your computer, download and install the Cobb Tuning Accessport Manager software. This software is essential for managing tunes and updates for your Accessport.
Step 5: Update the Accessport
Open the Accessport Manager software and connect your Accessport to the computer using the USB cable. Follow the prompts to check for any firmware updates and install them if available.
Step 6: Select Your Tune
Once updated, navigate through the Accessport interface to select the appropriate tune for your Toyota 86. Cobb provides several pre-defined maps, including those for stock and modified vehicles.
Step 7: Flash the Tune to Your ECU
After selecting the desired tune, follow the prompts on the Accessport to flash the tune to your vehicle’s ECU. This process may take several minutes, and it’s important not to turn off the ignition during this time.
Step 8: Verify the Installation
Once the flashing process is complete, the Accessport will prompt you to restart the vehicle. After restarting, check that the Accessport displays the correct tune and that there are no error messages.
Step 9: Data Monitoring
Utilize the data monitoring features of the Accessport. You can view real-time parameters such as boost pressure, air-fuel ratio, and engine temperature to ensure everything is functioning properly.
Step 10: Enjoy Your Upgraded Performance
With the Cobb Accessport successfully installed, take your Toyota 86 for a test drive. Experience the enhanced performance and enjoy the benefits of your upgrade!
Conclusion
The installation of the Cobb Accessport on your Toyota 86 is a straightforward process that can significantly improve your vehicle’s performance. With proper tuning and monitoring, you can maximize the potential of your sports car. Always remember to follow safety precautions and consult with professionals if you have any doubts during the installation process.
Additional Resources
For further reading and resources, consider the following:
- Cobb Tuning Official Website: Access additional maps and updates.
- Toyota 86 Owners Forum: Connect with other enthusiasts for tips and advice.
- Performance Tuning Guides: Explore more about tuning options for your vehicle.