Table of Contents
Installing HKS Hypermax coilovers on your S2000 AP2 can significantly enhance your vehicle’s handling and performance. This step-by-step guide will walk you through the installation process, ensuring you achieve the best results.
Tools and Materials Needed
- HKS Hypermax Coilovers
- Jack and jack stands
- Socket set
- Wrench set
- Torque wrench
- Spring compressors
- Penetrating oil
- Safety goggles
- Gloves
Preparation
Before starting the installation, ensure your workspace is safe and organized. Gather all the tools and materials listed above. It’s advisable to wear safety goggles and gloves during the installation process.
Step 1: Lifting the Vehicle
Begin by parking your S2000 on a flat surface. Use the jack to lift the front of the vehicle, then place jack stands underneath for safety. Repeat this process for the rear of the vehicle.
Step 2: Removing the Stock Suspension
Start with the front suspension. Remove the wheel using the socket set. Once the wheel is off, locate the stock coilover assembly. Apply penetrating oil to the bolts to ease removal.
Using the wrench set, remove the bolts securing the coilover to the hub and the upper mount. Carefully take out the stock coilover assembly.
Repeat for Rear Suspension
Follow the same process for the rear suspension. Remove the rear wheels, then detach the stock coilovers from the hub and upper mount. Keep all hardware for reinstallation.
Step 3: Preparing the HKS Hypermax Coilovers
Before installing the new coilovers, adjust the ride height and damping settings according to your preference. Use the provided instructions from HKS for specific settings.
Step 4: Installing the HKS Coilovers
Begin with the front coilovers. Position the new coilover assembly into the mounting location. Align it with the hub and upper mount. Secure it in place using the original bolts, tightening them with the torque wrench to the manufacturer’s specifications.
Repeat for Rear Coilovers
Install the rear coilovers in the same manner. Ensure all bolts are tightened securely. Double-check that everything is aligned correctly before moving on.
Step 5: Reinstalling the Wheels
Once the coilovers are installed, it’s time to put the wheels back on. Carefully place each wheel onto the hub and hand-tighten the lug nuts. After all wheels are on, lower the vehicle back to the ground.
Step 6: Final Checks
With the vehicle back on the ground, use the torque wrench to tighten all lug nuts to the specified torque. Check the coilover installation to ensure everything is secure and properly aligned.
Step 7: Alignment and Testing
After installation, it’s crucial to get a professional wheel alignment. This ensures optimal handling and tire wear. Once aligned, take your S2000 for a test drive to feel the improvements in handling and performance.
Conclusion
Installing HKS Hypermax coilovers on your S2000 AP2 can greatly enhance your driving experience. By following this step-by-step guide, you can ensure a successful installation. Enjoy your improved ride!