Table of Contents
Installing an HKS Super Power Flow Intake on your Mitsubishi Evo can significantly enhance its performance. This guide will walk you through the entire process, ensuring that you can complete the installation in approximately three hours. Follow each step carefully to ensure a successful installation.
Tools and Materials Needed
- HKS Super Power Flow Intake Kit
- Socket wrench set
- Screwdriver set
- Torque wrench
- Rubber gloves
- Shop towel or rag
- Zip ties
Preparation Steps
Before starting the installation, ensure your work area is clean and organized. Gather all tools and materials listed above. It is also advisable to wear rubber gloves to keep the engine components clean.
Safety Precautions
Always ensure the engine is cool before starting work. Disconnect the battery to avoid any electrical issues. Wear safety glasses to protect your eyes from debris.
Step-by-Step Installation Guide
Step 1: Remove the Stock Air Intake
Begin by locating the stock air intake system. Use a socket wrench to remove the bolts securing the airbox. Disconnect any clamps or hoses attached to the intake. Carefully lift out the stock air intake and set it aside.
Step 2: Prepare the HKS Intake
Unbox the HKS Super Power Flow Intake kit and lay out all components. Familiarize yourself with the parts, including the intake filter, piping, and any necessary adapters. Ensure you have all parts before proceeding.
Step 3: Install the New Intake Piping
Begin the installation by attaching the new piping to the throttle body. Use the provided clamps to secure the piping in place. Make sure it is positioned correctly to avoid any interference with other engine components.
Step 4: Attach the HKS Filter
Attach the HKS filter to the end of the intake piping. Ensure it is securely fastened using the provided clamps. This step is crucial for optimal airflow and performance.
Step 5: Check for Proper Fitment
Once everything is connected, double-check all fittings and connections. Ensure that the intake system is properly aligned and does not interfere with any moving parts. Make adjustments as necessary.
Step 6: Reconnect the Battery
Reconnect the battery that you had previously disconnected. Make sure all connections are tight and secure to prevent any electrical issues.
Testing the Installation
After the installation, it’s essential to test the vehicle to ensure everything is functioning correctly. Start the engine and listen for any unusual sounds. Check for any leaks around the intake.
Performance Check
Take the car for a short drive to assess the performance of the new intake. You should notice improved throttle response and acceleration. If everything feels right, your installation is complete!
Maintenance Tips
To keep your HKS Super Power Flow Intake in optimal condition, perform regular maintenance. Clean the filter as recommended by the manufacturer, and check for any loose connections periodically.
Filter Cleaning Procedure
When cleaning the filter, use a mild soap solution and rinse it thoroughly. Allow it to dry completely before reinstalling it. This will ensure the best airflow and performance.
Conclusion
Installing the HKS Super Power Flow Intake on your Mitsubishi Evo is a straightforward process that can yield significant performance benefits. By following this guide, you can confidently complete the installation and enjoy the enhanced driving experience.