Table of Contents
Installing H&R Sport Springs on your Audi S3 2.0 TFSI can significantly enhance handling and improve the overall stance of your vehicle. This guide will walk you through the process step-by-step, ensuring a smooth installation.
Tools and Materials Needed
- H&R Sport Springs
- Jack and jack stands
- Socket set
- Torque wrench
- Spring compressor
- Safety glasses
- Gloves
Before beginning the installation, gather all the necessary tools and materials. This will help streamline the process and ensure you have everything on hand.
Preparation
Start by parking your Audi S3 on a flat surface. Engage the parking brake and ensure that the vehicle is secure before lifting it. It is advisable to wear safety glasses and gloves during the installation.
Step 1: Lifting the Vehicle
Using a jack, lift the front of the vehicle and secure it with jack stands. Repeat this process for the rear of the vehicle. Ensure the vehicle is stable before proceeding.
Removing the Stock Springs
Step 2: Disassembling the Suspension
Begin by removing the wheel on the side you are working on. Use a socket set to remove the bolts securing the suspension components. Carefully detach the strut from the knuckle and lower control arm.
Step 3: Compressing the Springs
Using a spring compressor, carefully compress the stock spring to relieve tension. Ensure the spring is securely held in place before removing the top strut mount bolts.
Step 4: Removing the Stock Spring
Once the top strut mount is detached, carefully remove the stock spring from the strut assembly. Take note of how the spring is oriented for proper installation of the new springs.
Installing H&R Sport Springs
Step 5: Positioning the New Springs
Place the H&R Sport Spring onto the strut assembly, ensuring it is oriented correctly. The end of the spring should sit in the designated pocket on the strut.
Step 6: Reassembling the Strut
Carefully reattach the top strut mount and tighten the bolts to the manufacturer’s specifications using a torque wrench. Make sure everything is secure before moving on to the next step.
Reinstalling the Suspension
Step 7: Reattaching the Strut Assembly
Reinstall the strut assembly back into the vehicle. Secure it to the knuckle and lower control arm with the bolts you previously removed. Make sure to tighten all bolts to the specified torque settings.
Step 8: Repeating for Other Side
Repeat the above steps for the other side of the vehicle. It is important to ensure both sides are installed correctly for balanced handling.
Final Steps
Step 9: Lowering the Vehicle
Once both sides are complete, carefully lower the vehicle back to the ground using the jack. Remove the jack stands and ensure the vehicle is stable.
Step 10: Wheel Installation
Reinstall the wheels and hand-tighten the lug nuts. Once all wheels are back on, use a torque wrench to tighten the lug nuts to the specified torque settings.
Post-Installation Checks
After installation, it is crucial to perform a post-installation check. This includes inspecting all bolts and components for tightness and ensuring there are no unusual noises while driving.
Conclusion
Installing H&R Sport Springs on your Audi S3 2.0 TFSI is a great way to enhance handling and improve the vehicle’s stance. With careful attention to detail and following this guide, you can achieve professional results in your own garage.