Table of Contents
Installing H&R Sport Springs on your Macan Turbo can enhance both the aesthetics and performance of your vehicle. This guide will walk you through every step of the installation process, ensuring that you achieve a successful upgrade.
Tools and Materials Needed
- H&R Sport Springs
- Jack and jack stands
- Socket set
- Torque wrench
- Spring compressor
- Safety glasses
- Gloves
- Flathead screwdriver
- Ratchet
- Shop manual for torque specifications
Preparation
Before starting the installation, ensure that you have all the necessary tools and materials. Park your Macan Turbo on a flat surface and engage the parking brake. It’s also advisable to wear safety glasses and gloves during the process.
Step 1: Lifting the Vehicle
Use a jack to lift the front of the vehicle and secure it with jack stands. Repeat this process for the rear. Ensure the vehicle is stable before proceeding.
Step 2: Removing the Wheels
Using a socket set, remove the lug nuts and take off the wheels. This will give you access to the suspension components.
Front Suspension Disassembly
Step 3: Disconnecting the Strut
Locate the upper strut mount and remove the bolts using a socket set. Then, disconnect the sway bar link and the brake line bracket. Make sure to support the strut as you remove the bolts.
Step 4: Removing the Strut Assembly
Once the strut is disconnected, carefully pull it out of the wheel well. Use a spring compressor to safely compress the spring before removing it from the strut assembly.
Step 5: Installing H&R Sport Springs
With the spring compressed, install the H&R Sport Spring onto the strut assembly. Ensure that it is seated properly and then slowly release the spring compressor.
Reassembling the Front Suspension
Step 6: Reinstalling the Strut Assembly
Insert the strut assembly back into the wheel well. Reattach the upper strut mount and secure it with bolts. Reconnect the sway bar link and the brake line bracket.
Step 7: Replacing the Wheel
Put the wheel back on and hand-tighten the lug nuts. Lower the vehicle back to the ground and then use a torque wrench to tighten the lug nuts to the manufacturer’s specifications.
Rear Suspension Disassembly
Step 8: Accessing the Rear Struts
Lift the rear of the vehicle and remove the rear wheels. Locate the rear strut assembly and remove the lower bolts with a socket set.
Step 9: Removing the Rear Strut
Disconnect the upper strut mount by removing the bolts. Carefully pull the strut out of the assembly and use a spring compressor to compress the rear spring.
Step 10: Installing H&R Sport Springs in the Rear
Replace the stock spring with the H&R Sport Spring on the rear strut. Ensure it is properly seated and carefully release the spring compressor.
Reassembling the Rear Suspension
Step 11: Reinstalling the Rear Strut
Insert the rear strut back into the assembly and secure it with the upper and lower bolts. Make sure everything is tightened according to the specifications.
Step 12: Replacing the Rear Wheels
Reattach the rear wheels and hand-tighten the lug nuts. Lower the vehicle and torque the lug nuts to the correct specifications.
Final Steps
Once all components are reassembled, double-check all bolts and connections. It’s crucial to ensure everything is secure before driving the vehicle.
Step 13: Alignment Check
After installation, take your Macan Turbo to a professional for a wheel alignment. This step is essential to ensure proper handling and tire wear.
Step 14: Test Drive
Finally, take your vehicle for a test drive. Pay attention to the handling and comfort. Make sure everything feels right and there are no unusual noises.
Conclusion
Installing H&R Sport Springs on your Macan Turbo can significantly improve the vehicle’s performance and appearance. By following this step-by-step guide, you can ensure a successful installation and enjoy your upgraded ride.