Installing K&n Cold Air Intake on Your Acura Integra Type R: Step-by-step Power Boost

by

Upgrading your Acura Integra Type R with a K&N Cold Air Intake can significantly enhance engine performance and efficiency. This step-by-step guide will walk you through the installation process, ensuring you achieve that desired power boost.

Why Choose a K&N Cold Air Intake?

K&N is a reputable brand known for its high-performance air filters and intake systems. Here are some reasons to consider their cold air intake:

  • Improved Performance: Increases horsepower and torque.
  • Better Fuel Efficiency: Optimizes air flow for better combustion.
  • Reusable Filter: Washable and reusable, saving money over time.

Tools and Materials Needed

Before starting the installation, gather the following tools and materials:

  • Tools:
    • Socket wrench set
    • Screwdrivers (flathead and Phillips)
    • Pliers
    • Torque wrench
  • Materials:
    • K&N Cold Air Intake Kit
    • New hose clamps
    • Silicone lubricant (optional)

Step-by-Step Installation Guide

Step 1: Prepare Your Vehicle

Park your Acura Integra Type R on a flat surface and engage the parking brake. Allow the engine to cool down to prevent burns during installation.

Step 2: Remove the Stock Air Intake System

Begin by disconnecting the negative battery terminal to prevent electrical issues. Then, follow these sub-steps:

  • Loosen the hose clamps securing the stock air intake to the throttle body.
  • Disconnect any sensors or hoses attached to the intake.
  • Remove the stock intake assembly from the engine bay.

Step 3: Install the K&N Cold Air Intake

With the stock intake removed, you can now install the K&N Cold Air Intake:

  • Position the K&N intake pipe in place, aligning it with the throttle body.
  • Secure the intake pipe using the provided hose clamps.
  • Reconnect any sensors or hoses that were disconnected earlier.

Step 4: Install the K&N Air Filter

Next, attach the K&N air filter to the end of the intake pipe:

  • Slide the K&N air filter onto the intake pipe.
  • Secure it with the provided hose clamp, ensuring a tight fit.

Step 5: Finalize the Installation

Double-check all connections and clamps to ensure everything is secure. Reconnect the negative battery terminal. Finally, start the engine and listen for any unusual sounds.

Testing Your New Setup

Once installed, it’s essential to test the performance of your new cold air intake. Here’s how to do it:

  • Take your Integra for a short drive to assess throttle response.
  • Monitor any changes in engine noise, especially at higher RPMs.
  • Check for any warning lights on the dashboard.

Maintenance Tips

To ensure your K&N Cold Air Intake continues to perform optimally, follow these maintenance tips:

  • Regularly check and clean the air filter according to K&N guidelines.
  • Inspect hoses and clamps for signs of wear or damage.
  • Consider re-oiling the filter every 50,000 miles or as needed.

Conclusion

Installing a K&N Cold Air Intake on your Acura Integra Type R is a straightforward process that can yield significant performance benefits. By following this guide, you can enhance your vehicle’s power and efficiency while enjoying the satisfaction of a DIY upgrade.