Table of Contents
Installing suspension components can significantly enhance your vehicle’s performance and handling. In this guide, we will walk you through the process of installing KYB and Eibach suspension components on your BRZ.
Tools and Materials Needed
- KYB shock absorbers
- Eibach springs
- Socket set
- Torque wrench
- Spring compressors
- Jack and jack stands
- Wheel chocks
- Safety glasses
- Gloves
Preparation
Before starting the installation, ensure that you have all the necessary tools and materials at hand. Park your BRZ on a flat surface, engage the parking brake, and place wheel chocks behind the rear wheels for safety.
Step 1: Raise the Vehicle
Using a jack, lift the front of the vehicle and secure it on jack stands. Make sure the vehicle is stable before proceeding.
Step 2: Remove the Front Wheels
Loosen the lug nuts on the front wheels and remove them completely. Set the wheels aside in a safe location.
Removing the Old Suspension Components
Step 3: Remove the Strut Assembly
Locate the top strut bolts in the engine bay and remove them using a socket wrench. Then, remove the lower bolts securing the strut to the steering knuckle.
Step 4: Remove the Springs from the Strut Assembly
Using spring compressors, carefully compress the coil spring on the strut assembly. Once compressed, remove the top nut and carefully release the spring from the strut.
Installing the New Suspension Components
Step 5: Install the Eibach Springs
Place the new Eibach spring onto the strut assembly. Ensure that it is seated correctly before proceeding.
Step 6: Reassemble the Strut
Once the spring is in place, use the top nut to secure it. Ensure that everything is tightened to the manufacturer’s specifications.
Step 7: Reinstall the Strut Assembly
Position the strut assembly back into the wheel well. Secure the lower bolts to the steering knuckle and then the top bolts in the engine bay.
Finishing Up
Step 8: Reinstall the Front Wheels
Once the strut assembly is securely in place, reinstall the front wheels and hand-tighten the lug nuts.
Step 9: Lower the Vehicle
Carefully lower the vehicle back to the ground using the jack. Once on the ground, use a torque wrench to tighten the lug nuts to the recommended specifications.
Final Checks
After installation, it is essential to check the alignment of your vehicle. Improper alignment can lead to uneven tire wear and compromised handling.
Step 10: Test Drive
Take your BRZ for a test drive to ensure that everything is functioning correctly. Pay attention to the handling and any unusual noises that may indicate a problem.
Conclusion
Installing KYB and Eibach suspension components on your BRZ can greatly improve your driving experience. By following this step-by-step guide, you can ensure a successful installation and enjoy enhanced performance on the road.