Installing Stoptech Trophy Track Brake Kit: a Step-by-step Guide for Better Stopping Power

by

Upgrading your vehicle’s braking system is essential for enhancing performance, especially for track enthusiasts. The StopTech Trophy Track Brake Kit provides superior stopping power and improved heat management. This guide will walk you through the installation process step-by-step.

Tools and Materials Needed

  • StopTech Trophy Track Brake Kit
  • Jack and jack stands
  • Socket set
  • Torque wrench
  • Brake cleaner
  • Brake grease
  • Flathead and Phillips screwdrivers
  • Rubber mallet

Preparation Steps

Before you begin the installation, it’s crucial to prepare your workspace and vehicle. Follow these steps:

  • Park your vehicle on a level surface.
  • Engage the parking brake.
  • Loosen the lug nuts on the wheels you will be working on.
  • Raise the vehicle with a jack and secure it with jack stands.

Removing the Old Brake Components

To install the StopTech Trophy Track Brake Kit, you first need to remove the existing brake components. Follow these steps:

  • Remove the wheel by taking off the lug nuts.
  • Locate the brake caliper and remove the bolts securing it in place.
  • Carefully slide the caliper off the rotor. If it’s stuck, use a rubber mallet to gently tap it free.
  • Remove the brake pads from the caliper bracket.
  • Take off the rotor by removing any retaining screws and sliding it off the hub.

Installing the StopTech Trophy Track Brake Kit

With the old components removed, you can proceed with the installation of the new brake kit. Follow these steps:

  • Start by installing the new rotor onto the hub. Ensure it’s seated properly.
  • Apply brake grease to the caliper bracket where the brake pads will sit.
  • Insert the new brake pads into the caliper bracket.
  • Carefully position the new caliper over the brake pads and rotor.
  • Secure the caliper by tightening the bolts to the manufacturer’s specifications.

Completing the Installation

Once the new brake components are installed, it’s time to reassemble everything:

  • Replace the wheel and hand-tighten the lug nuts.
  • Lower the vehicle back to the ground.
  • Using a torque wrench, tighten the lug nuts to the specified torque setting.
  • Repeat the installation process for the other wheels.

Final Steps and Testing

After installing the brake kit on all wheels, follow these final steps:

  • Start the vehicle and pump the brake pedal a few times to ensure proper engagement.
  • Check for any leaks around the calipers.
  • Take the vehicle for a short test drive to ensure everything is functioning correctly.
  • Monitor the brakes during the first few drives to ensure they are performing as expected.

Conclusion

Installing the StopTech Trophy Track Brake Kit is a straightforward process that can significantly improve your vehicle’s braking performance. With the right tools and a bit of patience, you can enhance your driving experience on the track. Always remember to follow safety precautions and consult the manufacturer’s instructions for specific details regarding your vehicle.