Table of Contents
Installing a Tesla-boosted cold air intake on your B8 A4 2.0T can yield significant performance improvements, including an estimated 10 horsepower gain. This guide will walk you through the step-by-step process of installation, ensuring that you can achieve these enhancements effectively and safely.
Tools and Materials Needed
- Tesla-boosted cold air intake kit
- Socket wrench set
- Flathead screwdriver
- Phillips screwdriver
- Torque wrench
- Rubber gloves
- Safety glasses
- Shop towels
Preparation Steps
Before beginning the installation, make sure your vehicle is parked on a flat surface and the engine is cool. Gather all the necessary tools and materials to ensure a smooth installation process.
Disconnect the Battery
Start by disconnecting the negative battery terminal to prevent any electrical shorts during the installation.
Remove the Engine Cover
Using the socket wrench, remove the bolts securing the engine cover. Carefully lift it off and set it aside.
Removing the Stock Air Intake
Next, you will need to remove the stock air intake system to make way for the new Tesla-boosted cold air intake.
Disconnect the Airflow Sensor
Unplug the electrical connector from the mass airflow sensor located on the stock air intake tube.
Remove the Intake Tube
Loosen the hose clamps securing the intake tube to both the throttle body and the air filter box. Carefully pull the intake tube away from the engine.
Take Out the Air Filter Box
Remove any bolts securing the air filter box in place. Lift the air filter box out of the engine bay and set it aside.
Installing the Tesla-Boosted Cold Air Intake
With the stock intake system removed, you can now proceed with the installation of the Tesla-boosted cold air intake.
Position the New Air Filter
Place the new air filter in the designated area where the stock air filter box was located. Ensure it fits snugly and securely.
Attach the Intake Tube
Connect the new intake tube to the throttle body. Make sure to tighten the hose clamp securely to prevent any air leaks.
Reconnect the Airflow Sensor
Plug the mass airflow sensor back into its connector on the new intake tube.
Final Steps
After the new cold air intake is installed, it’s time to reassemble everything and check your work.
Reinstall the Engine Cover
Carefully place the engine cover back onto the engine bay and secure it with the bolts you previously removed.
Reconnect the Battery
Reconnect the negative battery terminal and ensure it is tight and secure.
Testing Your Installation
Start your engine and let it idle for a few minutes. Listen for any unusual sounds that may indicate a problem with the installation.
Take a Test Drive
After ensuring everything is functioning correctly, take your B8 A4 2.0T for a test drive to experience the performance gains. You should notice improved throttle response and acceleration.
Conclusion
Installing a Tesla-boosted cold air intake on your B8 A4 2.0T is a straightforward process that can enhance your vehicle’s performance significantly. By following this step-by-step guide, you should be able to achieve a gain of approximately 10 horsepower, improving your driving experience.