Installing the Afe Power Momentum Gt Intake on Your Toyota Tundra I-force Max: Step-by-step Guide

by

Installing the AFE Power Momentum GT Intake on your Toyota Tundra i-FORCE MAX can enhance your vehicle’s performance significantly. This step-by-step guide will walk you through the installation process, ensuring you have all the necessary information to complete the task efficiently.

Tools and Materials Needed

  • AFE Power Momentum GT Intake Kit
  • Socket set
  • Ratchet wrench
  • Flathead screwdriver
  • Phillips screwdriver
  • Torque wrench
  • Shop towel or rag
  • Safety glasses

Preparation

Before starting the installation, ensure your vehicle is parked on a level surface and the engine is cool. Gather all your tools and the AFE Power Momentum GT Intake kit. Read through the instructions provided in the kit to familiarize yourself with the components.

Step 1: Remove the Factory Intake System

Begin by disconnecting the negative battery terminal to prevent any electrical issues. Next, locate the factory air intake system components.

  • Remove the air intake duct by loosening the clamps using a flathead screwdriver.
  • Disconnect the mass air flow (MAF) sensor harness by pressing the release tab and pulling it off.
  • Unbolt the airbox using a socket set and remove it from the engine bay.

Step 2: Install the AFE Power Momentum GT Intake

With the factory intake removed, you can now install the AFE Power Momentum GT Intake. Follow these steps carefully:

  • Position the AFE airbox in the engine bay and secure it using the provided hardware.
  • Connect the rubber coupler to the throttle body and tighten the clamps.
  • Install the air filter into the airbox, ensuring it fits snugly.
  • Reconnect the MAF sensor harness to the new intake tube.

Step 3: Final Checks

Once the intake is installed, double-check all connections and fittings. Ensure that there are no loose clamps or bolts. It’s essential to make sure everything is secure to prevent any air leaks.

  • Inspect the air filter to ensure it is properly seated.
  • Check the MAF sensor connection for a secure fit.
  • Verify that the intake duct is correctly aligned with the throttle body.

Step 4: Reconnect the Battery

After confirming that everything is installed correctly, reconnect the negative battery terminal. This step is crucial to restore power to your vehicle’s electrical systems.

Step 5: Test Drive

Finally, take your Toyota Tundra for a test drive. Pay attention to the engine’s performance and listen for any unusual noises. The AFE Power Momentum GT Intake should provide improved throttle response and a more aggressive sound.

Maintenance Tips

To ensure optimal performance from your AFE Power Momentum GT Intake, regular maintenance is essential. Here are some tips:

  • Inspect the air filter regularly and clean or replace it as needed.
  • Check the intake system for any loose connections or signs of wear.
  • Follow the manufacturer’s recommendations for maintenance intervals.

Conclusion

Installing the AFE Power Momentum GT Intake on your Toyota Tundra i-FORCE MAX is a straightforward process that can significantly enhance your vehicle’s performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved airflow and engine efficiency.