Table of Contents
Installing the AFE Power Momentum GT Intercooler on your Silverado 2.7 Turbo can significantly enhance your vehicle’s performance. This guide will walk you through the entire process, ensuring that you have all the necessary information and steps to complete the installation efficiently.
Tools and Materials Needed
- AFE Power Momentum GT Intercooler Kit
- Socket set
- Wrenches
- Torque wrench
- Flathead screwdriver
- Phillips screwdriver
- Ratchet straps
- Coolant (if necessary)
- Shop towels
- Safety goggles
Preparation Steps
Before you begin the installation, it is essential to prepare your workspace and vehicle. Follow these steps to ensure a smooth process:
- Park your Silverado on a flat surface and engage the parking brake.
- Disconnect the negative battery terminal to prevent any electrical issues.
- Allow the engine to cool down completely before starting the installation.
- Gather all tools and materials listed above for easy access.
Removing the Stock Intercooler
The first step in the installation process is to remove the stock intercooler. Follow these detailed steps:
- Remove the front grille by unscrewing the retaining clips and bolts.
- Disconnect the air intake duct from the throttle body.
- Unplug any electrical connectors attached to the intercooler.
- Loosen the clamps on both sides of the stock intercooler.
- Carefully remove the stock intercooler from its mounting brackets.
Installing the AFE Power Momentum GT Intercooler
With the stock intercooler removed, you can now install the AFE Power Momentum GT Intercooler. Follow these steps for a successful installation:
- Position the AFE intercooler in place, ensuring it aligns with the factory mounting points.
- Secure the intercooler using the provided mounting hardware.
- Reconnect the air intake duct to the throttle body, ensuring a snug fit.
- Attach any electrical connectors that were previously disconnected.
- Ensure all clamps are tightened securely on both sides of the intercooler.
Finishing Touches
After the intercooler is installed, there are a few final steps to complete the installation:
- Reinstall the front grille, securing it with the clips and bolts.
- Reconnect the negative battery terminal.
- Check for any leaks in the intercooler and associated hoses.
- Start the engine and allow it to idle for a few minutes, monitoring for any unusual sounds.
- Take the vehicle for a test drive to ensure proper operation and performance.
Conclusion
Installing the AFE Power Momentum GT Intercooler on your Silverado 2.7 Turbo can greatly enhance your vehicle’s performance and efficiency. By following this complete guide, you can ensure a successful installation that will provide you with the benefits of improved airflow and reduced temperatures. Always remember to follow safety precautions and consult a professional if you encounter any difficulties.