Table of Contents
The AMS Performance Stage 2 Kit is a popular upgrade for the Porsche 911 Turbo, providing enhanced performance and driving experience. This article will guide you through the installation process step-by-step, ensuring that you can complete the upgrade with confidence.
What You Will Need
- AMS Performance Stage 2 Kit
- Basic hand tools (wrenches, sockets, screwdrivers)
- Torque wrench
- Jack and jack stands
- Safety goggles and gloves
Preparation
Before starting the installation, ensure that your workspace is clean and organized. Gather all necessary tools and parts to avoid interruptions during the process. Make sure the vehicle is parked on a flat surface and the engine is cool.
Step 1: Raise the Vehicle
Using a jack, lift the front of the 911 Turbo and secure it with jack stands. Ensure that the vehicle is stable before proceeding to the next steps.
Step 2: Remove the Front Bumper
To access the necessary components, you will need to remove the front bumper. Start by unscrewing the screws and bolts securing the bumper in place. Carefully detach the bumper and set it aside.
Step 3: Disconnect the Factory Intercoolers
Locate the factory intercoolers and disconnect the hoses attached to them. Be cautious of any residual coolant that may spill during this process. Remove the intercoolers from their mounting points.
Step 4: Install the AMS Intercoolers
Take the new AMS intercoolers and position them in the same location as the factory units. Secure them using the provided mounting hardware. Ensure that all connections are tight and leak-free.
Step 5: Upgrade the Charge Pipes
Replace the factory charge pipes with the upgraded AMS charge pipes. Connect them to the intercoolers and the throttle bodies, ensuring a secure fit. Tighten all clamps to prevent any boost leaks.
Step 6: Install the High-Flow Fuel Injectors
Remove the engine cover to access the fuel injectors. Disconnect the electrical connectors and remove the factory injectors. Install the high-flow fuel injectors from the AMS kit, making sure they are seated properly.
Step 7: Reassemble and Reconnect
Once all components are installed, reassemble any parts that were removed during the process. Reconnect all electrical connectors and hoses, ensuring everything is secure.
Step 8: Reinstall the Front Bumper
Carefully place the front bumper back onto the vehicle. Align it with the mounting points and secure it with the screws and bolts removed earlier. Double-check that everything is aligned correctly.
Step 9: Lower the Vehicle
Using the jack, carefully lower the vehicle back to the ground. Remove the jack stands and ensure the car is stable before starting the engine.
Step 10: Test Drive
Start the engine and let it idle for a few minutes. Check for any leaks or unusual noises. Once everything appears normal, take the car for a test drive to experience the performance improvements.
Conclusion
Installing the AMS Performance Stage 2 Kit on your 911 Turbo can significantly enhance its performance. By following these step-by-step instructions, you can ensure a successful installation and enjoy the benefits of your upgraded vehicle.