Table of Contents
Installing the APS 300-HP Turbo Kit on your Subaru BRZ can significantly enhance your car’s performance. This guide provides a comprehensive, step-by-step approach to ensure a smooth installation process.
What You Will Need
- APS 300-HP Turbo Kit
- Basic hand tools (wrenches, sockets, screwdrivers)
- Torque wrench
- Jack and jack stands
- Safety glasses
- Gloves
- Coolant
- Engine oil
Preparation Steps
Before starting the installation, ensure that you have a clean workspace and all necessary tools and parts ready. It is also advisable to read through the entire installation manual that comes with the APS turbo kit.
1. Safety First
Always wear safety glasses and gloves while working on your vehicle. Make sure to work in a well-ventilated area and keep all flammable materials away from your workspace.
2. Disconnect the Battery
Before you begin any work on the vehicle, disconnect the negative terminal of the battery to prevent any electrical shorts or shocks.
Removing the Stock Components
To install the APS turbo kit, you first need to remove several stock components from your Subaru BRZ. This includes the intake manifold, exhaust manifold, and other related parts.
1. Remove the Intake Manifold
Start by removing the intake manifold. This involves disconnecting any sensors, vacuum lines, and bolts holding it in place. Carefully lift it off and set it aside.
2. Remove the Exhaust Manifold
Next, remove the exhaust manifold. Be cautious of any remaining exhaust gases and ensure that all connections are properly disconnected before removing the manifold.
Installing the APS 300-HP Turbo Kit
With the stock components removed, you are now ready to install the APS 300-HP Turbo Kit. Follow these steps carefully to ensure a successful installation.
1. Install the Turbocharger
Begin by mounting the turbocharger onto the exhaust manifold. Ensure that all bolts are tightened to the manufacturer’s specifications using a torque wrench.
2. Connect the Intake Piping
Attach the intake piping to the turbocharger, ensuring that all clamps are secure. Check for any potential leaks before proceeding.
3. Install the Intercooler
Install the intercooler in the designated area, connecting it to the intake and turbo piping. Make sure all connections are tight to avoid any boost leaks.
4. Connect the Oil Lines
Connect the oil feed and return lines to the turbocharger. Ensure that these connections are secure and free of leaks.
5. Reinstall the Intake Manifold
Once the turbo and related components are installed, carefully reinstall the intake manifold. Reconnect all sensors and vacuum lines that were removed earlier.
6. Reinstall the Exhaust Manifold
Reattach the exhaust manifold, ensuring all bolts are tightened to the specified torque settings. Double-check all connections for leaks.
Final Steps
After installing the APS 300-HP Turbo Kit, it’s time to finalize the installation and prepare your vehicle for testing.
1. Reconnect the Battery
Reconnect the negative terminal of the battery. Ensure that all tools and equipment are removed from the engine bay before doing so.
2. Check Fluid Levels
Check the coolant and engine oil levels, topping them off as necessary. This is crucial for the performance and longevity of your turbocharged engine.
3. Start the Engine
Start the engine and let it idle for a few minutes. Listen for any unusual noises and check for leaks around the turbo and other connections.
4. Perform a Test Drive
After ensuring everything is functioning correctly, take your Subaru BRZ for a test drive. Monitor the performance and check for any issues during the drive.
Conclusion
Installing the APS 300-HP Turbo Kit on your Subaru BRZ can be a rewarding project that enhances your vehicle’s performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of turbocharging.