Installing the Bimmerworld Oil Cooler Kit on the F87 M2: Improve Temps and Reliability

by

The BMW F87 M2 is a performance-oriented vehicle that demands high levels of reliability and cooling efficiency. One of the best upgrades to enhance the performance and longevity of your M2 is the installation of the BimmerWorld Oil Cooler Kit. This article will guide you through the process of installing this essential component to improve your vehicle’s temperatures and reliability.

Why Upgrade to an Oil Cooler?

High-performance engines generate significant heat, which can lead to various problems if not managed properly. An oil cooler helps maintain optimal operating temperatures, ensuring that the engine oil remains effective in lubricating and protecting engine components. Here are a few reasons why upgrading to an oil cooler is beneficial:

  • Enhanced Cooling: Keeps oil temperatures lower during aggressive driving.
  • Increased Reliability: Reduces the risk of engine wear and failure.
  • Improved Performance: Maintains consistent oil viscosity for better engine performance.

Tools and Materials Needed

Before starting the installation, ensure you have the following tools and materials:

  • Socket set
  • Torque wrench
  • Flathead and Phillips screwdrivers
  • Oil cooler kit from BimmerWorld
  • New oil and filter
  • Rags for cleanup

Step-by-Step Installation Guide

Step 1: Prepare the Vehicle

Begin by parking your F87 M2 on a flat surface and engaging the parking brake. Allow the engine to cool down completely before starting the installation process. Gather all your tools and materials to ensure a smooth workflow.

Step 2: Remove the Front Bumper

To access the oil cooler installation area, you need to remove the front bumper. Follow these steps:

  • Remove the screws and clips securing the bumper.
  • Disconnect any electrical connectors for lights or sensors.
  • Carefully pull the bumper away from the vehicle and set it aside.

Step 3: Drain Engine Oil

Next, drain the engine oil to prevent spills during the installation:

  • Place a drain pan under the oil pan.
  • Remove the oil drain plug and allow the oil to fully drain.
  • Replace the drain plug once the oil has drained.

Step 4: Install the Oil Cooler

Now it’s time to install the BimmerWorld oil cooler:

  • Remove the stock oil cooler if applicable.
  • Position the new oil cooler in place and align it with the mounting points.
  • Secure the oil cooler using the provided hardware, ensuring a tight fit.

Step 5: Connect Oil Lines

Connect the oil lines to the new cooler:

  • Attach the inlet and outlet lines to the cooler, ensuring they are properly seated.
  • Use the provided clamps to secure the lines and prevent leaks.

Step 6: Refill Engine Oil

After installing the cooler, refill the engine with new oil:

  • Remove the oil filler cap.
  • Pour in the recommended amount of new oil.
  • Replace the oil filler cap securely.

Step 7: Reassemble the Front Bumper

With the oil cooler installed and the oil refilled, reassemble the front bumper:

  • Align the bumper with the mounting points.
  • Reconnect any electrical connectors.
  • Secure the bumper with screws and clips.

Testing Your Installation

Once the installation is complete, it’s crucial to test the system:

  • Start the engine and let it idle for a few minutes.
  • Check for any leaks around the oil cooler and lines.
  • Monitor the oil temperature during your next drive to ensure the cooler is functioning correctly.

Conclusion

Installing the BimmerWorld Oil Cooler Kit on your F87 M2 is a straightforward process that can significantly enhance your vehicle’s performance and reliability. By keeping oil temperatures in check, you can ensure that your engine runs smoothly and efficiently, even under demanding conditions. Enjoy your upgraded M2 and the peace of mind that comes with improved cooling!