Table of Contents
The Edelbrock E-Force Supercharger is a popular aftermarket modification for the Ram 1500, providing significant power and performance enhancements. This guide will walk you through the complete installation process step-by-step.
Tools and Materials Needed
- Edelbrock E-Force Supercharger Kit
- Basic hand tools (wrenches, sockets, screwdrivers)
- Torque wrench
- Impact wrench
- Coolant
- Engine oil
- Shop towels
- Safety glasses
- Gloves
Preparation
Before starting the installation, ensure you have all the necessary tools and materials at hand. Additionally, it’s advisable to read through the entire installation manual provided by Edelbrock for specific details related to your Ram 1500 model.
Safety Precautions
Always wear safety glasses and gloves while working on your vehicle. Make sure the engine is cool before starting the installation to avoid burns or injuries.
Step 1: Remove the Factory Intake System
Begin by disconnecting the negative battery terminal to prevent any electrical shorts. Next, remove the factory air intake system by following these steps:
- Loosen the clamps on the intake tube.
- Disconnect any sensors attached to the intake.
- Remove the air filter and intake tube.
- Take out the factory throttle body if necessary.
Step 2: Install the Supercharger Bracket
With the factory intake removed, you can now install the supercharger bracket. Follow these instructions:
- Position the supercharger bracket onto the engine.
- Align it with the factory mounting points.
- Secure the bracket using the supplied bolts, ensuring they are torqued to the specifications in the manual.
Step 3: Install the Supercharger Unit
Once the bracket is securely in place, it’s time to install the supercharger unit:
- Carefully place the supercharger onto the bracket.
- Connect the necessary hoses and fittings as per the installation guide.
- Secure the supercharger with the provided hardware.
Step 4: Reinstall the Throttle Body
After the supercharger is mounted, reinstall the throttle body onto the supercharger:
- Align the throttle body with the intake manifold.
- Tighten the bolts to the recommended torque settings.
- Reconnect any sensors and electrical connections.
Step 5: Connect the Intake System
With the throttle body in place, reconnect the intake system:
- Attach the intake tube to the throttle body.
- Secure the clamps to ensure no air leaks.
- Reinstall the air filter.
Step 6: Install the Fuel System Upgrades
The Edelbrock E-Force Supercharger requires upgraded fuel delivery. Follow these steps:
- Replace the factory fuel injectors with the ones provided in the kit.
- Install the upgraded fuel pump if included.
- Ensure all fuel lines are securely connected.
Step 7: Connect the Supercharger’s Wiring
Next, connect the wiring harness for the supercharger:
- Locate the wiring harness in the kit.
- Connect it to the supercharger and throttle body.
- Ensure all connections are secure and properly insulated.
Step 8: Refill Fluids
After all components are installed, refill the engine coolant and oil as required:
- Add coolant to the radiator.
- Check and refill engine oil if necessary.
Step 9: Reconnect the Battery and Start the Engine
Reconnect the negative battery terminal and start the engine:
- Listen for any unusual noises.
- Check for leaks around the supercharger and fuel system.
- Allow the engine to idle and warm up.
Step 10: Test Drive and Tune
Finally, take your Ram 1500 for a test drive. Monitor the performance and ensure everything is functioning correctly:
- Check for any warning lights on the dashboard.
- Observe engine performance and responsiveness.
- Consider a professional tune for optimal performance.
Conclusion
Installing the Edelbrock E-Force Supercharger on your Ram 1500 can significantly enhance its performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of increased power and efficiency.