Installing the Edelbrock Performer Rpm Intake Manifold: a Complete Step-by-step Guide

by

The Edelbrock Performer RPM Intake Manifold is a popular choice for performance enthusiasts looking to enhance their engine’s capabilities. This guide will walk you through the installation process step-by-step, ensuring that you achieve optimal performance from your vehicle.

Tools and Materials Needed

Before beginning the installation, gather the following tools and materials:

  • Socket set
  • Wrench set
  • Torque wrench
  • Gasket scraper
  • New intake manifold gasket
  • Thread sealant
  • Clean rags
  • Engine oil
  • Vacuum cleaner

Preparation Steps

Proper preparation is essential for a successful intake manifold installation. Follow these steps:

  • Disconnect the battery to prevent electrical shorts.
  • Remove any components obstructing access to the intake manifold, such as the air cleaner and throttle linkage.
  • Label all hoses and wires for easy reinstallation.
  • Clean the engine’s intake surface thoroughly using a gasket scraper and vacuum cleaner.

Removing the Old Intake Manifold

To install the Edelbrock Performer RPM, you must first remove the existing intake manifold. Follow these steps:

  • Loosen and remove the bolts securing the old intake manifold.
  • Carefully lift the manifold off the engine, ensuring not to damage any surrounding components.
  • Inspect the old gasket and intake surface for any debris or damage.

Installing the Edelbrock Performer RPM Intake Manifold

Now that the old manifold is removed, it’s time to install the new Edelbrock Performer RPM intake manifold. Follow these steps:

  • Apply a thin layer of engine oil to the new gasket surfaces to ensure a good seal.
  • Position the new intake manifold over the engine, aligning it with the dowel pins.
  • Carefully lower the manifold onto the engine, making sure it sits evenly.

Securing the Manifold

Once the manifold is in place, it’s crucial to secure it properly:

  • Insert and hand-tighten the intake manifold bolts in a crisscross pattern to ensure even pressure.
  • Use a torque wrench to tighten the bolts to the manufacturer’s specifications.

Reconnecting Components

After the manifold is secured, reconnect all components that were removed during the preparation phase:

  • Reattach the throttle linkage and air cleaner.
  • Reconnect all hoses and wires, ensuring they are properly secured.
  • Double-check all connections for tightness and correct placement.

Final Steps

Before starting your engine, complete the following final steps:

  • Reconnect the battery.
  • Check the oil level and top off if necessary.
  • Start the engine and allow it to idle, checking for any leaks around the intake manifold.
  • Take the vehicle for a test drive to ensure proper operation.

Troubleshooting Common Issues

During or after installation, you may encounter some common issues. Here are troubleshooting tips:

  • If the engine runs rough, check for vacuum leaks around the intake manifold.
  • Ensure all bolts are properly torqued to specifications.
  • Verify that all electrical connections are secure and functioning.

Conclusion

Installing the Edelbrock Performer RPM Intake Manifold can significantly enhance your engine’s performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of improved power and efficiency.