Table of Contents
Installing the Garrett GT2871R turbo on your RSX can significantly enhance your vehicle’s performance. This guide will walk you through each step of the installation process, ensuring that you have a smooth experience.
Tools and Materials Needed
- Garrett GT2871R Turbo
- Turbo manifold
- Oil feed and return lines
- Intercooler piping
- Wastegate
- Boost controller
- Basic hand tools (wrenches, sockets, etc.)
- Torque wrench
- Gasket maker
- Safety glasses and gloves
Preparation Steps
Before starting the installation, ensure that your RSX is parked on a level surface and the engine is cool. Gather all the tools and materials listed above to avoid interruptions during the installation process.
Disconnect the Battery
Begin by disconnecting the negative terminal of the battery. This step is crucial to prevent any electrical shorts while working on your vehicle.
Remove the Stock Turbo (if applicable)
If your RSX is already equipped with a stock turbo, you will need to remove it. Start by loosening the clamps on the intake and exhaust sides, followed by disconnecting the oil feed and return lines. Carefully remove the turbo from the manifold.
Installing the Garrett GT2871R Turbo
Mount the Turbo Manifold
Install the new turbo manifold onto the engine. Ensure that you use new gaskets to prevent any leaks. Tighten the manifold bolts to the manufacturer’s specifications using a torque wrench.
Attach the Garrett GT2871R Turbo
Place the Garrett GT2871R turbo onto the manifold and secure it with the provided bolts. Make sure it is seated properly, and then tighten the bolts to the recommended torque settings.
Connect Oil Lines
Connect the oil feed line from the engine to the turbo. Ensure that it is tight and leak-free. Next, connect the oil return line to the turbo and secure it properly.
Install the Intercooler Piping
Attach the intercooler piping to the turbo outlet. Ensure that all clamps are secure and that there are no leaks. If your kit includes a blow-off valve, install it according to the manufacturer’s instructions.
Connect the Wastegate
Install the wastegate onto the turbo. Connect the wastegate actuator to the boost controller, ensuring that the lines are secure and free from kinks.
Final Steps
Double-Check All Connections
Before starting the engine, double-check all connections, including oil lines, intercooler piping, and electrical connections. This step is crucial to ensure everything is secure and leak-free.
Reconnect the Battery
Reconnect the negative terminal of the battery. Make sure it is tight to prevent any disconnections while driving.
Start the Engine
Start the engine and allow it to idle for a few minutes. Check for any oil leaks or unusual noises. If everything appears normal, you can take your RSX for a test drive.
Conclusion
Installing the Garrett GT2871R turbo on your RSX can be a rewarding project that enhances your vehicle’s performance. By following this step-by-step guide, you can ensure a successful installation and enjoy the benefits of increased power and efficiency.