Installing the Greddy Tuner Kit on Your Brz Fa20: a Complete Step-by-step Guide

by

The GReddy Tuner Kit is a popular choice among car enthusiasts looking to enhance the performance of their Subaru BRZ FA20. This guide will provide you with a detailed, step-by-step approach to installing the kit, ensuring you can maximize your vehicle’s potential.

What You Will Need

  • GReddy Tuner Kit
  • Socket wrench set
  • Screwdriver set
  • Torque wrench
  • Lift or jack stands
  • Safety glasses
  • Gloves

Before starting, ensure you have all the necessary tools and equipment. Safety should always be your top priority. Wear safety glasses and gloves to protect yourself during the installation process.

Preparation Steps

Before diving into the installation, follow these preparation steps:

  • Park your vehicle on a flat surface.
  • Disconnect the battery to prevent any electrical issues.
  • Lift the car using a jack and secure it with jack stands.

Once you have prepared your vehicle, you are ready to begin the installation process.

Step-by-Step Installation

Step 1: Remove the Stock Air Intake

Start by removing the stock air intake system. Follow these sub-steps:

  • Loosen the clamps securing the intake tube to the throttle body.
  • Disconnect any sensors attached to the intake.
  • Remove the intake system from the engine bay.

Step 2: Install the GReddy Intake Pipe

Once the stock intake is removed, install the GReddy intake pipe:

  • Position the GReddy intake pipe in place.
  • Secure it using the provided clamps.
  • Reconnect any sensors you previously disconnected.

Step 3: Attach the GReddy Air Filter

Next, attach the GReddy air filter to the intake pipe:

  • Slide the air filter onto the end of the intake pipe.
  • Secure it with the provided clamp.

Step 4: Install the GReddy Blow-Off Valve

Now, it’s time to install the blow-off valve:

  • Locate the designated area for the blow-off valve.
  • Attach the valve using the provided hardware.
  • Ensure all connections are tight and secure.

Step 5: Connect the GReddy Tuner Kit to the ECU

The next step involves connecting the tuner kit to the vehicle’s ECU:

  • Locate the ECU harness in your vehicle.
  • Follow the instructions provided with the kit to make the necessary connections.
  • Double-check all connections for security.

Step 6: Reconnect the Battery

After completing the installation, reconnect the battery:

  • Reattach the negative terminal first.
  • Ensure all connections are tight.

Step 7: Test the Installation

Finally, it’s time to test your installation:

  • Start the engine and listen for any unusual sounds.
  • Check for leaks around the intake and blow-off valve.
  • Take the car for a test drive to ensure everything is functioning properly.

Conclusion

By following this step-by-step guide, you can successfully install the GReddy Tuner Kit on your BRZ FA20. Enjoy the improved performance and enhanced driving experience that comes with this upgrade!