Table of Contents
Installing the HKS GT II Turbo on your Civic Type R can significantly enhance your vehicle’s performance. This comprehensive step-by-step guide will walk you through the installation process, ensuring you have all the necessary information to complete the task successfully.
Tools and Materials Needed
- HKS GT II Turbo Kit
- Socket set
- Torque wrench
- Screwdrivers (flathead and Phillips)
- Wrenches
- Oil and coolant
- Gaskets and seals
- Heat-resistant gloves
- Safety glasses
- Shop towels
Preparation
Before starting the installation, ensure that your Civic Type R is parked on a level surface and that the engine is cool. Gather all the tools and materials listed above to streamline the process.
Disconnect the Battery
Begin by disconnecting the negative terminal of the battery. This step is crucial for safety, as it prevents any electrical shorts during the installation.
Remove the Engine Cover
Next, remove the engine cover by unscrewing the bolts that secure it in place. Set the cover aside in a safe location.
Removing the Stock Turbo
To install the HKS GT II Turbo, you first need to remove the stock turbo. Follow these steps carefully to avoid damaging any components.
Drain the Coolant
Start by draining the coolant from the radiator. Locate the drain plug at the bottom of the radiator and allow the coolant to flow into a suitable container.
Remove Exhaust Components
Next, detach the exhaust components connected to the stock turbo. This may include the downpipe and any associated heat shields. Use a socket set to remove the bolts securely.
Disconnect Intake and Oil Lines
Carefully disconnect the intake pipe and oil lines from the stock turbo. Be cautious of any residual oil that may leak out during this process.
Unbolt the Stock Turbo
Finally, unbolt the stock turbo from the engine. Lift it out carefully, ensuring not to damage any surrounding components.
Installing the HKS GT II Turbo
With the stock turbo removed, you can now install the HKS GT II Turbo. Follow these steps for a successful installation.
Prepare the New Turbo
Before installation, ensure that the HKS GT II Turbo is ready. Check that all gaskets and seals are in place and that the unit is clean.
Install the New Turbo
Position the HKS GT II Turbo onto the engine and secure it with the bolts provided in the kit. Make sure to torque the bolts to the manufacturer’s specifications.
Reconnect Oil and Intake Lines
Reconnect the oil lines and intake pipe to the new turbo. Ensure that all connections are tight and secure to prevent leaks.
Reattach Exhaust Components
Reattach the exhaust components, including the downpipe and any heat shields. Use a torque wrench to ensure everything is tightened to the correct specifications.
Refill Coolant
After everything is secured, refill the coolant in the radiator. Make sure to use the appropriate coolant for your vehicle.
Final Steps
With the installation complete, it’s time to reconnect the battery and start the engine to check for any leaks or issues.
Reconnect the Battery
Reconnect the negative terminal of the battery and ensure it is secured properly.
Start the Engine
Start the engine and let it idle for a few minutes. Check for any signs of leaks around the turbo and connections. If everything looks good, take your Civic Type R for a test drive.
Conclusion
Installing the HKS GT II Turbo on your Civic Type R can greatly enhance performance. By following this comprehensive guide, you can ensure a successful installation and enjoy the benefits of increased power and efficiency.