Table of Contents
Installing the H&R Performance Suspension on your AMG GT can significantly enhance your vehicle’s handling and ride quality. This DIY guide will walk you through the steps needed to complete this installation successfully.
Tools and Materials Needed
- H&R Performance Suspension Kit
- Jack and jack stands
- Socket set
- Wrench set
- Torque wrench
- Spring compressors
- Safety glasses
- Gloves
Before starting the installation, ensure you have all the necessary tools and materials. This will help you avoid interruptions during the process.
Preparation Steps
Begin by parking your AMG GT on a flat surface and engaging the parking brake. This will ensure your vehicle remains stable during the installation.
Next, gather your tools and materials in a well-lit area. Wearing safety glasses and gloves is recommended to protect yourself while working.
Removing the Old Suspension
To remove the old suspension, follow these steps:
- Loosen the lug nuts on the wheels, but do not remove them yet.
- Use the jack to lift the vehicle and secure it with jack stands.
- Remove the lug nuts and take off the wheels.
- Locate the suspension components, including struts and springs.
- Using the socket set, remove the bolts securing the struts to the vehicle.
- Carefully use spring compressors to release tension on the springs.
- Remove the springs from the struts.
Ensure that you keep all bolts and components organized for reassembly later.
Installing the H&R Performance Suspension
Once the old suspension is removed, it’s time to install the H&R Performance Suspension:
- Start by placing the new springs onto the struts.
- Carefully use the spring compressors to secure the springs in place.
- Align the struts with the mounting points on the vehicle.
- Insert and hand-tighten the bolts to secure the struts.
- Use a torque wrench to tighten the strut bolts to the manufacturer’s specifications.
- Repeat the process for all four corners of the vehicle.
Make sure everything is tightened properly to ensure safety and performance.
Reassembling the Vehicle
After installing the new suspension, it’s time to reassemble the vehicle:
- Reattach the wheels and hand-tighten the lug nuts.
- Lower the vehicle from the jack stands.
- Once the vehicle is on the ground, use the torque wrench to tighten the lug nuts to the specified torque.
Ensure that all components are secured and nothing is left loose.
Final Checks and Test Drive
Before taking your AMG GT for a test drive, perform the following final checks:
- Double-check all bolts and connections.
- Inspect the suspension for any signs of improper installation.
- Ensure that the vehicle is at the correct ride height.
Once you are satisfied with your installation, take the vehicle for a test drive. Pay attention to the handling and ride quality to ensure everything is functioning as expected.
Conclusion
Installing the H&R Performance Suspension on your AMG GT can be a rewarding DIY project. With the right tools and careful attention to detail, you can enhance your vehicle’s performance and enjoy a smoother ride.